INTRODUCTION
Before you begin, we urge you to take a few minutes to completely read this manual so that you can get the best use of the equipment. This manual details the
PARTS
•Complete optical tube assembly (objective lens diameter = 70mm; focal length = 700mm)
•
•MA25mm (28X), MH9mm eyepieces (1.25" O.D. “Outside Diameter”)
•Diagonal mirror (1.25" O.D.), 2X barlow
•Red dot viewfinder
•Altazimuth mount
•Hardware package with bolts, wingnuts, nuts, etc. necessary for assembly
•Astronomy software (separate instructions supplied in software package)
ASSEMBLY
You will need a
1.Remove and identify the telescope’s components, using the listing above.
2.Attach the 3 aluminum tripod legs (7, Fig. 1) to the base of the altazimuth mount (25, Fig. 1) with the 3 leg brace supports (8, Fig. 1) facing inward. Line up the holes of the tripod legs with the holes on the mount base attachment (27, Fig. 1) and thread the three included bolts through the holes. Thread the wing nuts over the bolts and
3.To attach the leg braces to the tripod, line up the holes in the leg braces (9, Fig. 1) with the holes in the leg brace supports (8, Fig. 1) and slide the the included 1/2” screws through the holes. Thread the included nuts over the end of the bolts and
4.To attach the accessory tray (26, Fig. 1) to the leg braces (9, Fig. 1), place the round accessory tray over the over one of the leg braces. Slide a mounting screw through the hole in one of the corners of the tray, down through the slot in the leg brace. Thread a wingnut onto the bolt and tighten to a firm feel. Repeat this procedure until all three corners of the tray are mounted to the three leg braces.
5.Extend the sliding center portion of the adjustable height tripod leg (19, Fig. 1) to the desired length for all 3 legs. Lock the tripod legs by tightening the leg lock thumbscrew (20, Fig. 1) to a firm feel. See Inset A.
6.If the cradle ring assembly (5, Fig. 1) did not come attached to the optical tube (4, Fig. 1), loosen the cradle ring lock knob (6, Fig. 1) and open the cradle rings. Place the optical tube roughly in the center of the cradle rings and close the rings over the tube. Tighten the cradle ring lock knobs to a firm feel. Do not
7.Position the cradle ring’s mounting plate into the saddle plate slot (18, Fig. 1). Tighten the mounting lock knob (12, Fig. 1) to a firm feel.
8.Attach the red dot viewfinder bracket (24, Fig. 1) to the telescope using the 2 supplied thumbscrews. The thumbscrews thread over the 2 bolts located on the main tube.
11.Insert the diagonal mirror (13, Fig. 1) into the focuser drawtube (15, Fig. 1) and the MA 25mm eyepiece (1, Fig. 1) into the diagonal mirror. Tighten the respective thumbscrews to a firm feel.
12.The telescope is now completely assembled. To move the telescope and point it from one object another, first slightly loosen the vertical lock, then loosen the horizontal lock (11, Fig. 1). Loosening these locks allows the telescope to be moved freely (vertically or horizontally) in any direction so that the telescope can be positioned to center a terrestrial or celestial object in the telescopic field. Once an object is found, the vertical lock knob (10, Fig. 1) can be tightened and the vertical
– 5 –