Tascam CD-302 Important Safety Precautions, Do not cut off the mains plug from this equipment

Page 2

Important Safety Precautions

Note for U.K. Customers

DO NOT cut off the mains plug from this equipment.

If the plug fitted is not suitable for the power points in your home or the cable is too short to reach a power point, then obtain an appropriate safety approved extension lead or consult your dealer.

If nonetheless the mains plug is cut off, remove the fuse and dispose of the plug immediately, to avoid a possible shock hazard by inadvertent connection to the mains supply.

If this product is not provided with a mains plug, or one has to be fitted, then follow the instructions given below:

IMPORTANT: DO NOT make any connection to the larger terminal which is marked with the letter E or by the safety earth symbol ç or coloured GREEN or GREEN-and-YELLOW.

The wires in the mains lead on this product are coloured in accordance with the following code:

BLUE: NEUTRAL

BROWN: LIVE

As these colours may not correspond with the coloured markings identifying the terminals in your plug proceed as follows:

The wire which is coloured BLUE must be connected to the terminal which is marked with the letter N or coloured BLACK.

The wire which is coloured BROWN must be connected to the terminal which is marked with the letter L or coloured RED.

When replacing the fuse only a correctly rated approved type should be used and be sure to re-fit the fuse cover.

IF IN DOUBT — CONSULT A COMPETENT ELECTRICIAN.

TO THE USER

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications.

Operation of this equipment in a residental area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.

CAUTION

Changes or modifications to this equipment not expressly approved by TEAC CORPORATION for compliance could void the user’s authority to operate this equipment.

2 TASCAM CD-302

Image 2
Contents CD-302 Important Safety Precautions Do not cut off the mains plug from this equipmentImportant Safety Instructions For Canada Pour le CanadaTascam CD-302 Table of Contents Specifications and reference BPMEnvironmental conditions Main featuresBefore you start Anti-shock memory Before you start-Backup memoryBackup memory Instant startBefore you start-Preset functions Preset functionsBefore you start-Displayed characters Displayed charactersFront and rear panels Main unit front panel Remote control unit front panelFront and rear panels-Main unit front panel Main unit rear panelFront and rear panels-Remote control unit front panel Front and rear panels-Remote control unit rear Remote control unit rearFront and rear panels-Display DisplayPlay modes Basic operationsPlayback operations CueingBasic operations-Loop play Loop playPlayback in A-B loop play mode B loop play modeSetting A-B loop points Clearing loop pointsSingle loop ALL loopKey pitch control Advanced OperationsTempo speed control SamplingAdvanced Operations-Sampling Bend function Advanced Operations-Bend functionBPM Number key modes Cancellation of tempo syncAdvanced Operations-Number key modes Tempo SyncScratch Cancellation of beat syncAdvanced Operations-Scratch MemoriesAdvanced Operations-Memories Programmed playback Advanced Operations-Voice Reduce functionVoice Reduce function Brake function Advanced Operations-Output levelOutput level Deleting program stepsTimer Play Advanced Operations-Setting the EOM timeSetting the EOM time Auto ReadyRelay Play Direct modeAdvanced Operations-Relay Play Disc Tray Auto CloseFader and Event Start/Stop Factory PresetAdvanced Operations-Fader and Event Start/Stop Specifications Specifications and referenceDimensions Spare parts Specifications and reference-Error messages, etcError messages, etc