Motorola PTP 100 (FSK), PMP 100 Release 11.0 Features, SM Receive Target Level can now be

Release 11.0Release Notes and User Guide Supplement

4 Features

Release 11.0 adds the features listed in Table 1.

Table 1: Release 11.0 Features

Regions	Products	Feature	Description	See for
Affected	Affected			Details
All Regions	AP and SM	Support for the	RADIUS can be used for SM authentication,	Section 5
		RADIUS protocol.	SM configuration, and centralized AP and
			SM user name and password management.
All Regions	AP and SM	From AP GUI or	From the AP’s Tools > Sessions tab,	-
		SNMP, drop all	sessions to all SMs in the sector can be
		sessions in the	dropped. This forces all SMs in the sector to
		sector.	register again to an AP. Note that a session
			to a single selected SM can also be
			dropped.
All Regions	SM with NAT	Data entry checking	Data entry checking now prevents	-
	enabled		mistakenly setting the same IP address for
			both the LAN Interface and the Remote
			Configuration Interface on an SM with NAT
			enabled. These parameters are configured
			on the SM’s Configuration > NAT tab.
All Regions	PMP 100	Can configure 40 mile	On the AP’s Configuration > Radio tab, the	-
		max range on FSK	Max Range can now be configured up to 40
		AP.	miles (instead of the previous max of 30
			miles). Note, this does not change the
			transmit power of the radio, does not change
			the RF operation, and due to the additional
			turnaround time in the frame will reduce
			capacity and throughput to some degree.
All Regions	PMP 100	Can configure SM	On the AP’s Configuration > Radio tab, the	-
		receive target level up	SM Receive Target Level can now be
		to -40 dBm on FSK	configured up to -40 dBm (instead of the
		AP.	previous limit of -55 dBm). Note, this does
			not change the transmitter power of the AP,
			nor the sensitivity of the AP or the SM – it
			just allows a “hotter” SM receive target level
			if RF design requires it.

Issue 1, March 2011 Page 11