Bel Canto Design PReProTM warranty Example for Programming a Macro Sequence

Page 30

REMOTE CONTROL LEARNING MODE CONT.

Example for Programming a Macro Sequence

To program the M1 button in the AVC mode to power on the receiver, power on the CD, power on the TV and power on the VCR:

Step 1.

Press the AVC button and MUTE buttons simultaneously. Hold both buttons until the red light under the AVC button turns on. The red light will blink once during each subse- quent press of a button.

Step 2.

Press the M1 button to select the M1 macro.

Step 3.

Programming the M1 macro button: Press the AVC button to select the AVC Power command. Press the CD Device button to select the CD mode. Press the MUTE button to select the CD Power command. Press the TV Device button to select the TV mode. Press the MUTE button to select the TV Power command. Press the VCR Device but- ton to select the VCR mode. Press the MUTE button to select the VCR Power command.

Step 4.

Press the CH button. The red light under the AVC button will blink twice and then turn off indicating that the macro sequence has been stored.

© 2002/2003 bel canto design, Ltd.

Page 30

PRePro User’s Guide rev1103

Image 30

Contents Users Guide and Warranty Information PReProCongratulations General PrecautionsProduct Warranty Information UnpackingQuick Setup Placement GuidelinesAC Connecti AC Connection and Power RecommendationsQuick Setup Speaker Size Speaker SizeSpeaker Distance Loudspeaker Setup Loudspeaker Size and Subwoofer Setup Tuner Settings Input Audio AssignmentBass Trim Calibration Press Exit to get back to the Main MenuCompression Status DisplayReset to Defaults DVD Audio Full RangeAdvanced Setup Advanced Setup/Input Name ChangeHardware Setup Video Monitor Connection Multi-Channel Output Connection Digital Source Set-up & Connection To Change Input Assignment To Change Input Assignment NameAnalog Source Set-up & Connection To Change Input Assignment To Analog Setting up Zone Zone 2 TriggerGeneral Operation of Unit This button toggles Mutes on and off This button toggles TFT display on and off AC Power Fuse Holder Rear Panel ConnectionsRemote Control Controls and Functions Remote Control Learning Mode Learning a New Command Step Erasing a Learned Command From a Button Step Erasing All the Learned Commands in One Device Mode StepErasing All of the Learned Commands in All Device Modes Volume Punch Through Programming a Macro SequenceExample for Programming a Macro Sequence Listening Mode Definitions Listening ModesPRePro User’s Guide rev1103 Troubleshooting Guide Trouble Shooting the BasicsSpecifications AUDIO/VIDEO Section