220T Hub LEDs
The hub LEDs on the 220T indicate these conditions: collisions, status of internal bridging, if the hub is managed, and the condition of the hub’s power supply.
Intel Express 220T |
| |
Stackable Hub |
|
|
Colls 10Mbps | Bridged | Power |
Colls 100Mbps | Managed | Enable/Disable |
|
| |
RPS | Status | Bridging |
LED | Status | Meaning |
Colls 10Mbps | Blinking | Collisions detected on 10Mbps segment. |
Colls 100Mbps | Blinking | Collisions detected on 100Mbps segment. |
|
|
|
RPS | On (green) | Optional RPS is present and on standby. |
| Off | No RPS unit present. |
| On (red) | RPS is active; hub power supply failed. |
|
|
|
Bridged | On | 10Mbps and 100Mbps segments can |
|
| communicate. |
| Off | No communication between segments. |
|
|
|
Managed | On | Hub is managed by the optional |
|
| Management Module. |
| Off | Hub is not managed. |
|
|
|
Status | On | Hub is operating normally. |
| Blinking | Hub has an internal hardware or software |
|
| problem. See descriptions for the right |
|
| port LED on page 4. |
|
|
|
Managed and Status | Blinking | Hub failed to load its internal software. |
|
|
|
Power | On | Hub is receiving power. |
| Off | Hub is not receiving power. |
|
|
|
5