Eiki LC-XGC500 Capture function does not work, Remote Control does, Wired remote control does not

Appendix

Capture function does not work.	– Check the connection and the Input signal to see if there is signal.
The Remote Control does	– Check the batteries.
not work..	– Make sure no obstruction is between the projector and remote control.
	– Make sure you are not too far from the projector when using the
	remote control. Maximum operating range is 16.4’ (5 m).
	– Make sure that the remote control code conforms to the projector’s
	code. See page 53.
	– Unlock the Key lock function for the remote control. See page 56.
	– Wireless remote control does not work when the remote control cable
	is connected to the projector.
The wired remote control does not	– When the standby mode is set to "ECO", the same remote control code
work to the projector on..	should be set on both the projector and the remote control to turn the
	projector on.
Wireless Mouse function does	– Check the connection between the projector and your computer.
not work..	– Check the mouse setting on your computer.
	– Turn on the projector before you turn on the computer.
	– Make sure the computer input is selected.
	– Make sure that the mouse driver is installed in your computer. To use the
	moue as a wireless mouse, the mouse driver needs to be installed in
	the computer.
Indicator blinks or lights..	– Check the status of the projector with referring to "Indicators and
	Projector Condition." See pages 73-75.
The exclamation mark appears	– Your operation is invalid. Operate correctly.
on the screen..
The top control does not work..	– Unlock Key lock for the projector in the Key lock function.
Unable to unlock the Logo PIN	– Contact the dealer where you purchased the projector or the service
code lock, Security key lock	center.
or Security PIN code lock..

WARNING :

High voltages are used to operate this projector.. Do not attempt to open the cabinet..

If problems still persist after following all operating instructions, contact the dealer where you purchased the projector or the service center. Specify the model number and explain about the problem. We will advise you how to obtain service.

The CE Mark is a Directive conformity mark of the European Community (EC).

This symbol on the nameplate means the product is Listed by Underwriters Laboratories Inc. It is designed and manufactured to meet rigid U.L. safety standards against risk of fire, casualty and electrical hazards.

70