Eiki LC-XE10 Video Input, Input Source Selection Video, S-Video, Y, Pb/Cb, Pr/Cr

Video Input

Input Source Selection {Video, S-Video, (Y, Pb/Cb, Pr/Cr)}

Direct Operation

Choose Video by pressing the INPUT button on the top control or the VIDEO button on the remote control.

Before using these buttons, correct input source should be selected through menu operation as described below.

INPUT button

Video

Computer 1

Computer 2

VIDEO button Video

✽

✽When Monitor out is selected at the Terminal item in the Setting Menu, Computer 2 is not displayed. See “Terminal” item on page 40.

Menu Operation

1Press the MENU button and the On-Screen Menu will appear. Press the Point Left/Right button to move the red frame pointer to the Input Menu icon.

2Press the Point Down button to move the red arrow pointer to Video and then press the SELECT button. The Source Select Menu will appear.

3Move the pointer to the source that you want to select and then press the SELECT button.

Auto	When selecting Auto, the projector automatically detects
	incoming video signal, and adjusts itself to optimize its
	performance. The projector selects connection in the
	following order:
	1st Y, Pb/Cb, Pr/Cr
	2nd S-Video
	3rd Video
	The Y, Pb/Cb, Pr/Cr jacks has priority over the S-VIDEO
	jack under the condition of connecting both the Y, Pb/Cb,
	Pr/Cr jacks and the S-VIDEO jack.
	The S-VIDEO jack has priority over the VIDEO jack under
	the condition of connecting both the S-VIDEO jack and
	the VIDEO jack.
	When video input signal is connected to the VIDEO jack,
Video
	select Video.
	When video input signal is connected to the S-VIDEO
S-Video
	jack, select S-Video.

Y, Pb/Cb, Pr/Cr

When video input signal is connected to the Y, Pb/Cb, Pr/Cr jacks, select Y, Pb/Cb, Pr/Cr.

NOTE

●See “Computer Input” on page 25 for a signal compatible with HDCP.

Input Menu

	Move the pointer to
VIDEO	Video and press the
	SELECT button.

Source Select Menu (VIDEO)

Move the pointer to the source that you want to select and press the SELECT button.

✽When Monitor out is selected at the Terminal item in the Setting Menu, Computer 2 is not displayed.

See “Terminal” item on page 40.

33