Setting
Power management
For reducing power consumption as well as maintaining the lamp life, the Power management function turns off the projection lamp when the projector is not operated for a certain period.
Select one of the following options:
Ready | When the lamp has been fully cooled |
| down, the POWER indicator changes |
| to green blinking. In this condition, |
| the projection lamp will be turned on if |
| the input signal is reconnected or any |
| button on the top control or remote |
Shut down | control is pressed. |
When the lamp has been fully cooled | |
Off | down, the power will be turned off. |
Power management function is off. | |
Timer | If the input signal is interrupted and |
| no button is pressed for more than |
| 30 seconds, the timer display with |
| No signal appears. It starts the |
| countdown until the lamp is turned off. |
| Use the Point ed buttons to set the |
| Timer(1~30min). |
✔Note:
Factory default is Ready: 5 min.
On start
When this function is set to On, the projector will be automatically turned on just by connecting the AC power cord to a wall outlet.
✔Note:
Be sure to turn off the projector properly (see “Turning Off the Projector” on page 22). If the projector is turned off in the incorrect sequence, the On start function does not work properly.
Power management
Time left before Lamp is off.
53