Eiki LC-XBL30 Maintenance and Cleaning Cleaning the Filters, Resetting the Filter Counter

Maintenance and Cleaning

Cleaning the Filters

Filter prevents dust from accumulating on the optical elements inside the projector. Should the filters become clogged with dust particles, it will reduce cooling fans’ effectiveness and may result in internal heat buildup and adversely affect the life of the projector. If a “Filter warning” icon appears on the screen, clean the filters immediately. Clean the filters by following the steps below.

1	Turn off the projector, and unplug the AC power cord
	from the AC outlet.
2	Remove the panel front assembly by pulling the latch
	horizontally.
	Remove the panel net by pulling the latch horizontally
	and then remove it leftward.
3	Clean the filters with a brush or rinse them softly.
4	When cleaning the filters by rinsing, dry them well.
	Replace the filters properly. Make sure that the filters

are fully inserted.

CAUTION

Do not operate the projector with the filters removed. Dust may accumulate on the optical elements degrading picture quality.

Do not put anything into the air vents. Doing so may result in malfunction of the projector.

Panel front assembly Pull horizontally and remove.

Note:

Please be sure to fit this edge when inserting this panel front assembly.

Spacer filter front

Panel

front

RECOMMENDATION

we recommend avoiding dusty/smoky environments when you operate the projector. Usage in these environments may cause poor image quality .

When using the projector under dusty or smoky conditions, dust may accumulate on a lens, LCD panels, or optical elements inside the projector degrading the quality of a projected image. When the symptoms above are noticed, contact your authorized dealer or service station for proper cleaning.

Resetting the Filter Counter

Be sure to reset the Filter counter after cleaning or replacing the filters.

1	Press the MENU button to display the On-Screen
	Menu. Use the Point ▲▼ buttons to select Setting and
	then press the Point ► or the SELECT button.
2	Use the Point ▲▼ buttons to select Filter counter and
	then press the Point ► or the SELECT button. Use the
	Point ▲▼buttons to select Filter counter reset and
	then press the SELECT button. Filter counter Reset?
	appears. Select yes to continue.
3	Another confirmation dialog box appears, select yes to
	reset the Filter counter.

Panel net (filter back)

Pull horizontally and then remove it leftward.

Filter counter

Filter counter

Reset? appears.

Select yes, then another confirmation box appears.

Select yes again to reset the Filter counter.

59