Intel I945P specifications Installation Jumper Settings, Settings Normal Default Clear Cmos

Page 20

Installation

3-2 Jumper Settings

JPCIE1

JPCIE2

JCMOS

JUSB

JCMOS: Clear CMOS data Jumper

If the CMOS data becomes corrupted or you forgot the supervisor or user password, clear the CMOS data to reconfigure the system back to the default values stored in the ROM BIOS.

Settings:

1-2: Normal (Default)

12-3: Clear CMOS

To CMOS Clear data, please follow the steps below.

1.Turn off the system.

2.Change the jumper from “1-2” to “2-3” position for a few seconds.

3.Replace the jumper back to the “1-2” position.

4.Turn on the system and hold down the <Del> key to enter BIOS setup.

JUSB: USB S3 Wake up Jumper

This jumper disconnects 5V standby voltage to USB devices. This means USB devices will not be able to wake-up the system from S3 (Suspend to RAM) power saving mode.

Settings:

1-2: Enabled (S3 enabled)

2-3: Disabled (No S3)

Page 3-4

Image 20
Contents Manual Revision October 25 Disclaimer of Warranties Post Port Frequently Asked Questions Table of Contents Section Driver Installation Left Blank Introduction Mainboard Features Ultra ATA100 Special Features Bios Features Magic Health System Block Diagram Introduction Specification Mainboard Specification ProcessorChipset Main MemoryIDE AudioOnboard connector and pin-header Peripheral InterfacesAt Rear Panel Front Panel ControllerSupported Operating System Specification Special FeaturesForm Factor Installation Mainboard LayoutInstallation Easy Installation Procedure CPU InstallationStep Installation Jumper Settings Settings Normal Default Clear CmosSupported Configuration Installation System Memory Configuration Dual Channel interfaceMemory configurations supported Memory InstallationInstallation VGA Card Installation PCI-E VGA Card Installation Device Connectors Jcpufan / Jpwrfan / JsysfanPW1 GND CUSB3 CUSB4 CFP CIR Cspk Installation Thermo Stick Function Optional Installation Acpi S3 Suspend To RAM Function Installation Acpi S3 Suspend To RAM Function Installation To enter the Setup Program Main MenuStandard Cmos Setup Standard Cmos SetupAdvanced Bios Features Bios Features SetupHyper-Threading Technology Advanced Chipset Features Chipset Features SetupDram Timing Selectable Integrated Peripherals PCI Express FunctionChipset IDE Devices Chipest Serial ATA Setting Legacy Devices Parallel Port Mode Power Management Setup Power ManagementPCI-E device PME function Options Enabled, Disabled Wake-Up by PCI Card PNP/PCI/PCI-E Configuration PCI Express related itemsInterrupt requests are shared as shown below PC Health StatusDisplays the current system/CPU temperature Smart Fan example Power Bios Features PowerBOIS FeaturesCPU CLOCK/SPEED Voltage Adjust Menu Load Optimized Defaults Defaults MenuLoad Fail-Safe Defaults Enter Password Supervisor/User Password SettingExiting Bios Save & Exit SetupSave to Cmos and Exit Y/N? Y Exit Without SavingDrivers Installation Easy Driver InstallationDrivers Installation Realtek Sound Manager Quick User-guide Sound EffectDrivers Installation Speaker Configuration Above shows the phone jack setup for 8 channel modeDrivers Installation General SpdifDrivers Installation Audio Wizard Audio WizardDrivers Installation Flashing the Bios AppendixKey in File Name to save previous Bios to file Appendix B Appendix Appendix If password is set, ask for password