Intel I945P specifications Chipest Serial ATA Setting

Page 43

BIOS

support Ultra DMA-33/66/100, select Auto to enable UDMA mode by BIOS. Options: Auto, Disabled.

* Chipest Serial ATA Setting *

Chipest Serial ATA

This sets the mode of SATA. Combined mode will force SATA to replace one of the traditional IDE Primary or Secondary ports. Enhanced mode allows Serial ATA to work simultaneously with Parallel -ATA.

Options: Disabled, Auto, Combined Mode, Enhanced Mode, SATA Only.

SATA Port Speed Settings

This item allows you to select Serial ATA port speed.

Options: Force GEN I-->1.5Gbps, Force GEN II-->3.0Gbps.

PATA IDE Mode

This option is available only when Chipset Serial ATA is in Combined mode. Assigning “Primary” will make PATA IDE the Primary port and the remaining SATA as Secondary port. Similarly, assigning “Secondary” will make PATA IDE the Secondary port and SATA as Primary port.

Options: Primary, Secondary.

Onboard Devices Setup

Scroll to Onboard Devices Setup and press <Enter>. The following screen appears:

USB Controller

Enables the USB controller.

Options: Disabled, Enabled.

USB 2.0 Controller

Enables the EHCI (USB2.0) controller.

Options: Disabled, Enabled.

Page 4-9

Image 43

Contents Manual Revision October 25 Disclaimer of Warranties Post Port Frequently Asked Questions Table of Contents Section Driver Installation Left Blank Introduction Mainboard Features Ultra ATA100 Special Features Bios Features Magic Health System Block Diagram Introduction Main Memory SpecificationMainboard Specification Processor ChipsetAudio IDEFront Panel Controller Onboard connector and pin-headerPeripheral Interfaces At Rear PanelForm Factor Specification Special FeaturesSupported Operating System Mainboard Layout InstallationCPU Installation Installation Easy Installation ProcedureStep Settings Normal Default Clear Cmos Installation Jumper SettingsSupported Configuration Dual Channel interface Installation System Memory ConfigurationMemory Installation Memory configurations supportedInstallation VGA Card Installation PCI-E VGA Card Jcpufan / Jpwrfan / Jsysfan Installation Device ConnectorsPW1 GND CUSB3 CUSB4 CFP CIR Cspk Installation Thermo Stick Function Optional Installation Acpi S3 Suspend To RAM Function Installation Acpi S3 Suspend To RAM Function Installation Main Menu To enter the Setup ProgramStandard Cmos Setup Standard Cmos SetupBios Features Setup Advanced Bios FeaturesHyper-Threading Technology Chipset Features Setup Advanced Chipset FeaturesDram Timing Selectable PCI Express Function Integrated PeripheralsChipset IDE Devices Chipest Serial ATA Setting Legacy Devices Parallel Port Mode Power Management Power Management SetupPCI-E device PME function Options Enabled, Disabled Wake-Up by PCI Card PCI Express related items PNP/PCI/PCI-E ConfigurationPC Health Status Interrupt requests are shared as shown belowDisplays the current system/CPU temperature Smart Fan example PowerBOIS Features Power Bios FeaturesCPU CLOCK/SPEED Voltage Adjust Menu Load Fail-Safe Defaults Defaults MenuLoad Optimized Defaults Supervisor/User Password Setting Enter PasswordExit Without Saving Exiting BiosSave & Exit Setup Save to Cmos and Exit Y/N? YEasy Driver Installation Drivers InstallationSound Effect Drivers Installation Realtek Sound Manager Quick User-guideAbove shows the phone jack setup for 8 channel mode Drivers Installation Speaker ConfigurationSpdif Drivers Installation GeneralAudio Wizard Drivers Installation Audio WizardDrivers Installation Appendix Flashing the BiosKey in File Name to save previous Bios to file Appendix B Appendix Appendix If password is set, ask for password