Intel I945P specifications Supported Configuration

Page 21

Installation

JPCIE1~JPCIE2:PCI-E slot Control Jumper

These jumpers redirect the PCI-E signals from PCI-EXP2 and PCI-EXP3 to the PCI-EXP4 connector. This allows 4x bandwidth on PCI-EXP4 slot to cater for higher bandwidth cards such as VGA and RAID connectors.

JPCIE2 JPCIE1

Settings:

1-2: PCI-E x4 mode (Default)

2-3: PCI-E x1 mode

Set both jumpers to 1-2 to use PCI-EXP4 as high bandwidth PCI-E x4 slot. Set both jumpers to 2-3 to use PCI-EXP2 and PCI-EXP3 slots.

Supported Configuration:

JPCIE1/JPCIE2	PCI-EXP4	PCI-EXP2	PCI-EXP3
Settings	PCI-EXP4	PCI-EXP2	PCI-EXP3
Settings
1-2	x4	O	O

2-3	x1	x1	x1

Jumpers JPCIE1 and JPCIE2 must always be set to the same mode.

Page 3-5

Image 21

Contents Manual Revision October 25 Disclaimer of Warranties Post Port Frequently Asked Questions Table of Contents Section Driver Installation Left Blank Introduction Mainboard Features Ultra ATA100 Special Features Bios Features Magic Health System Block Diagram Introduction Mainboard Specification Processor SpecificationChipset Main MemoryAudio IDEPeripheral Interfaces Onboard connector and pin-headerAt Rear Panel Front Panel ControllerSpecification Special Features Form FactorSupported Operating System Mainboard Layout InstallationCPU Installation Installation Easy Installation ProcedureStep Settings Normal Default Clear Cmos Installation Jumper SettingsSupported Configuration Dual Channel interface Installation System Memory ConfigurationMemory Installation Memory configurations supportedInstallation VGA Card Installation PCI-E VGA Card Jcpufan / Jpwrfan / Jsysfan Installation Device ConnectorsPW1 GND CUSB3 CUSB4 CFP CIR Cspk Installation Thermo Stick Function Optional Installation Acpi S3 Suspend To RAM Function Installation Acpi S3 Suspend To RAM Function Installation Main Menu To enter the Setup ProgramStandard Cmos Setup Standard Cmos SetupBios Features Setup Advanced Bios FeaturesHyper-Threading Technology Chipset Features Setup Advanced Chipset FeaturesDram Timing Selectable PCI Express Function Integrated PeripheralsChipset IDE Devices Chipest Serial ATA Setting Legacy Devices Parallel Port Mode Power Management Power Management SetupPCI-E device PME function Options Enabled, Disabled Wake-Up by PCI Card PCI Express related items PNP/PCI/PCI-E ConfigurationPC Health Status Interrupt requests are shared as shown belowDisplays the current system/CPU temperature Smart Fan example PowerBOIS Features Power Bios FeaturesCPU CLOCK/SPEED Voltage Adjust Menu Defaults Menu Load Fail-Safe DefaultsLoad Optimized Defaults Supervisor/User Password Setting Enter PasswordSave & Exit Setup Exiting BiosSave to Cmos and Exit Y/N? Y Exit Without SavingEasy Driver Installation Drivers InstallationSound Effect Drivers Installation Realtek Sound Manager Quick User-guideAbove shows the phone jack setup for 8 channel mode Drivers Installation Speaker ConfigurationSpdif Drivers Installation GeneralAudio Wizard Drivers Installation Audio WizardDrivers Installation Appendix Flashing the BiosKey in File Name to save previous Bios to file Appendix B Appendix Appendix If password is set, ask for password