Intel SBC-370 manual Peripheral Setup

Page 32

Offboard PCI IDE Card >: This function is used to specify whether or not an offboard PCI IDE card is installed in your computer. You must specify the slot number on the board which will be used for the card.

Offboard PCI IDE Primary (/Secondary) IRQ >: Specify the PCI interrupt that is assigned to the Pri- mary (/Secondary) IDE channel on the offboard PCI IDE controller.

PCI Slot (1,2,3,4) IRQ Priority >: Specify the IRQ priority to be used by the PCI devices on slots 1 to 4.

DMA Channel (0,1,3,5,6,7) >: Used to indicate whether or not the DMA channel is assigned for a PnP or ISA card.

IRQ (3,4,5,7,9,10,11,14,15) >: Assign the displayed IRQ to be used by a legacy ISA adapter card. The settings are ISA/EISA or PCI/PnP.

PERIPHERAL SETUP

This setup works mostly on Multi-I/O Chip (W83977F). The options are used to change the Chipset's registers. Carefully change any default setting to meet your application needs. The only concern is Onboard Serial Port 2. If you want to use the IrDA port, you have to configure the SIR or ASKIR model in the BIOS's Periph- eral Setup's COM2; the RS-232 COM2 will be disabled.

Onboard FDC >: Used to enable the FDC on your board. If you set it to Auto, the BIOS will automatically decide if the FDC should be enabled.

Onboard Serial Port A (/B) >: Specify the I/O port address of the serial port 1(/2). If you set it to Auto, the BIOS will decide the correct I/O port address automatically.

AMI BIOS Setup Menus

34

Page 31 Page 33
Image 32
Page 31 Page 33
Contents SBC-370 Socket 370 CELERON, PentiumBattery Replacement Caution Table of Contents AMI Bios Setup Menus Feature List OverviewAGP VGA Controller Ethernet ControllerUltra DMA/33 Enhanced PCI EDI Interface Multi-I/O ChipWatchdog Timer ATX Power Supply FunctionPower Consumption Hardware Monitoring SystemE2KEY Function Watchdog TimerOperating Humidity Connecting to AN ATX Power Supply SBC-370 through Power Button and +5VSBBoard Configuration Board LayoutCPU Frequency Setting JP3 CPU Multiplier Setting JP8Watchdog Timer Type Setting JP5 JumpersClear Cmos Setup JP4 Watchdog Timeout Period JP12DiskOnChip Memory Address Setting JP11 PS/2 Mouse Setting JP7 Connectors Floppy Disk Drive Connector CN2PCI E-IDE Disk Drive Connector CN1/CN3 Parallel Port CN4 CN11 Serial Port 2x5 pin header Connector COM2 Serial Ports CN12/CN11Keyboard/Mouse Connector CN8/CN17/CN18 External Switches and Indicators CN7 USB Port Connector CN9VGA Connector J1 IrDA Infrared Interface Port CN6Fan Connector CN13/CN14/CN15 LAN RJ45 Connector CN10LED Connector for LAN CN5 System Interrupts Irqs DMA Channel Assignments1ST MB Memory Address MAP MAPStandard Cmos Setup Getting StartedAdvanced Cmos Setup AMI Bios Setup Menus AMI Bios Setup Menus Advanced Chipset Setup AMI Bios Setup Menus Power Management Setup PCI/PLUG and Play Setup Peripheral Setup AMI Bios Setup Menus Hardware Monitor Setup Change SUPERVISOR/USER Password AUTO-DETECT Hard DiskAuto Configuration with Optimal Settings Exit Without Saving Auto Configuration with Fail Safe SettingsSave Settings and Exit Index Page 139908D Xycom Automation, Inc Canada Sales Fax
Top Page Image Contents