IrDA Infrared Interface Port (CN6)
The built-in IrDA port supports Serial Infrared (SIR) or Amplitude Shift Keyed IR (ASKIR) interface. To use the IrDA port, configure the SIR or ASKIR model in the BIOS's Peripheral Setup's COM2. Then, the normal RS-232 COM2 will be disabled. For the location of this connector, refer to figure 2.
Pin Number | Description |
1 | VCC |
2 | FIR-RX |
3 | IR-RX |
4 | GND |
5 | IR-TX |
6 | CIR-RX |
VGA Connector (J1)
The built-in 15-pin VGA connector can be connected directly to your monochrome CRT monitor as well as a high resolution color CRT monitor. For the location of this connector, refer to figure 2.
Pin Number | Description |
1 | RED |
2 | GREEN |
3 | BLUE |
4 | NC |
5 | GND |
6 | GND |
7 | GND |
8 | GND |
9 | VCC |
10 | GND |
11 | NC |
12 | DDC DATA |
13 | HSYNC |
14 | VSYNC |
15 | DDC CLK |