INSTALLATIONS
Turbo LED Connector: Pins 8 and 18
There is no turbo/deturbo function on the board. The Turbo LED on the control panel will always be On when attached to this connector.
Pin # | Signal Name |
8 | 5V |
18 | Ground |
Reset Switch: Pins 9 and 19
The reset switch allows the user to reset the system without turning the main power switch off and then on again. Orientation is not required when making a connection to this header.
Hard Disk Drive LED Connector: Pins 10 and 20 This connector connects to the hard drive activity LED on control panel. This LED will flash when the HDD is being accessed.
Pin # | Signal Name |
10 | Ground |
20 | 5V |
FAN1: CPU Fan Power Connector
FAN1 is a
3 2 1
Pin # | Signal Name |
|
|
1Ground
2+12V
3Rotation detection
I815E User’s Manual | 17 |