Diagrams are representational |
|
|
of the entire line of MANHATTAN |
|
|
docking kits and may not depict | SATA Connector | Power Connector |
specific cables/connectors. |
Mounting a Drive in the Drive Case
These steps are for installing a
NOTE: A special adapter kit is required in order to install a
1.Remove the drive case cover by sliding it toward the back of the unit.
2.If you plan to install a drive that features removable media, carefully punch out the center part of the front panel.
IMPORTANT: If you are installing a new hard drive in the case, you may need to configure the drive before you
install it. Refer to the drive manufacturer’s documentation and configure the
drive as Master, Cable Select or Slave depending on the configuration of your computer. After you complete this
installation, you may also need to