Installing the Docking Case

1.Turn off the power to your computer and any other connected peripheral devices. Follow these precautions for static electricity discharge:

•Discharge any static electricity buildup in your body by touching a grounded metal surface such as the computer case, if plugged in.

•During installation procedures, avoid any contact with internal device parts.

2.Unplug the power cord from the back of the computer.

3.Remove your computer’s cover.

4.Remove the computer’s front cover plate from the 5.25-inch drive bay in which you plan to install your MANHATTAN Hard Drive Docking Kit.

5.Remove (separate) the drive case from the docking case by lifting the handle and pulling it out.

6.Slide the docking case into the 5.25-inch drive bay.

7.Attach the SATA cable from the computer to the SATA connector on the back of the docking case.

8.Attach an available 4-pin power cable from the system’s power supply to the 4-pin connector on the back of the docking case. The power connector is “D”-shaped to ensure proper orientation when making the connection. (See image below.)

9.Replace the computer’s cover; reconnect the power and other external cabling.