
Chapter 2. Setting up the projector
This chapter provides information on positioning the projector, connecting a computer source, using the projector with Microsoft Windows, and displaying and adjusting a computer source image.
Starting and shutting down the projector
Please follow the steps below to start your projector, and to shut off the projector.
Attention: Before moving the projector, be sure to power down the projector normally and disconnect the projector from the main power source.
1.Connect the power cord to the projector as shown. Connect the other end to a wall outlet. The Power LED turns on and the buttons illuminate.
2.Remove the lens cover.
3.Attach input devices.
4.Turn on the connected devices.
5.Ensure the Power LED is on a steady (not flashing) orange and then press the Power button to turn on the projector. The projector splash screen displays and connected devices are detected.
Figure 2-1. Lenovo splash screen
Attention: Do not look directly into the projection lens when the lamp is turned on. The bright light might harm your eyes.
6.Use the appropriate appliance cable to connect to a video device.
7.To turn off the projector, press the Power button. The projector prepares for
© Lenovo 2006. Portions © IBM Corp. 2005. |