| Status/# of |
|
LED | Flashes | Description |
|
|
|
Power | 4 | System overheating |
|
|
|
| 5 | System interface error |
|
|
|
| 6 | Lamp error |
|
|
|
| 7 | Fan error (refer ready LED status to determine which fan) |
|
|
|
| 8 | Lamp cover open |
|
|
|
| 9 | DLP driver error |
|
|
|
| 10 | Color wheel error |
|
|
|
Note: If the projector LEDs flash in a manner that is not addressed above, unplug the power cable and contact your retailer.
Thermal protector
When the temperature inside the projector becomes abnormally high, the LED indicator flashes red (0.5 seconds on/0.5 seconds off) the Standby indicator is a steady red, and at the same time the temperature protector operates and switches off the power of the projector. If this happens, please follow the steps below:
1.Switch off the power and disconnected the power plug from the wall outlet.
2.Check the temperature of the room. If the projector is being used in a location with a high ambient temperature, set it up in a cooler location.
3.Check the vent openings to make sure that they are all clear. Clean the vent openings if they are obstructed.
4.Wait at least 1 hour until the temperature of the projector drops, then plug it in again.
5.If you are still having the same problem, please contact your retailer.
Appendix B. Troubleshooting