Lenovo 9159 manual Connecting drives

Page 25

Figura 14. Retaining bracket

Nota: When installing the Universal Adapter Bracket, if the retaining bracket is not available, install the screws to secure the adapter bracket into the drive bay.

6.Install the drive into the drive bay until it snaps into position.

Figura 15. Installing the drive

7.Align the drive bay assembly with the two slots and rails on the sides of the chassis and connect the new drive cable on the system board. See “Connecting drives”.

Connecting drives

The steps to connect a drive are different depending on the type of drive that you are connecting. Use one of the following procedures for your drive connection.

Connecting an optical drive or a parallel ATA hard disk drive:

1.Locate the two-connector signal cable that comes with your computer or with the new drive.

2.Locate the IDE connector 1 on the system board. See “Identifying parts on the system board” a pagina 7.

3.Connect one end of the signal cable to the drive and the other to the IDE connector 1 on the system board.

4.Locate the extra four-wire power connector labelled P4 and connect it to the drive.

Figura 16. Connecting a parallel ATA hard disk drive

Connecting an additional serial ATA hard disk drive: A serial hard disk drive can be connected to any available SATA connector.

1.Locate the signal cable that comes with the new drive.

Capitolo 3. Installing options and replacing hardware 17

Image 25

Contents Page Page ThinkCentre Hardware Installation and Replacement Guide Page Capitolo 2. Overview IndiceIv Hardware Installation and Replacement Guide Lenovo 2005, 2007. Portions IBM Corp Vi Hardware Installation and Replacement Guide Capitolo 1. Important safety information Hardware Installation and Replacement Guide Additional information resources Capitolo 2. OverviewHandling static-sensitive devices Locations Figura 1. Controls and connectorsFigura 2. Connector locations Locating connectors on the rear of your computerFigura 3. Component locations Locating componentsFigura 4. System board parts locations Identifying parts on the system boardHardware Installation and Replacement Guide Installing external options Capitolo 3. Installing options and replacing hardwareTools required Removing the coverFigura 5. Sliding the cover Accessing system board components and drivesInstalling memory Installing internal optionsHardware Installation and Replacement Guide What to do next Installing PCI adaptersFigura 11. Opening the adapter latch Installing internal drivesDrive specifications Installing a drive in bay Connecting drives Installing a diskette drive in bay Figura 20. Battery removal Replacing the batteryReplacing the hard disk drive Figura 21. Battery installationFigura 22. Removing the hard disk drive Figura 24. Removing the diskette drive Replacing the diskette driveReplacing an optical drive Figura 26. Installing the new diskette driveFigura 28. Retaining bracket for optical drive Replacing the heat sink and fan assemblyFigura 30. Removing the heat sink Figura 32. Removing the system fan assembly Replacing the system fan assemblyFigura 33. Removing the memory module Replacing a memory moduleFigura 35. Removing the adapter Replacing a PCI adapterReplacing a keyboard Figura 36. Installing the new adapterReplacing a mouse Figura 38. Mouse connectorsFigura 39. Sliding on the cover Capitolo 4. Completing the parts replacementObtaining device drivers Integrated cable lock Capitolo 5. Security featuresErasing a lost or forgotten password clearing Cmos Password protectionPadlock Capitolo 5. Security features Hardware Installation and Replacement Guide Appendice. Notices Trademarks Television output noticePage Numero parte 43C4818 Stampato in Italia