9.Align the drive bay assembly with the two slots and rails on the sides of the chassis, reconnect the drive cables on the system board, and then slide the drive bay assembly towards the rear of the chassis until it snaps into position.
10.Reinstall the front bezel.
11.Go to Capitolo 4, “Completing the parts replacement”, a pagina 31.
Replacing the diskette drive
Attention
Do not open your computer or attempt any repair before reading the “Important safety information” in the Safety and Warranty Guide that was included with your computer for the computer. To obtain copies of the Safety and Warranty Guide, go to http://www.lenovo.com/support.
This section provides instructions on how to replace the diskette drive.
1.Remove the computer cover. See “Removing the cover” a pagina 9.
2.Remove the bezel and drive bay assembly. See “Accessing system board components and drives” a pagina 10.
3.Release the diskette drive by pressing inward on the blue retainer at the side of the drive.
4.Remove the failing diskette drive by sliding it out the front of the drive bay assembly.
Figura 24. Removing the diskette drive
5.Remove the retainer bracket from the failing drive and install it on the new drive.
Figura 25. Retaining bracket for diskette drive
6.Install the new diskette drive into the drive bay from the front until it snaps into position.