Lenovo 9159 manual Installing a diskette drive in bay

Page 26

2.Locate the available SATA connector on the system board. See “Identifying parts on the system board” a pagina 7.

3.Connect one end of the signal cable to the drive and the other to the available SATA connector on the system board.

4.Locate one of the extra five-wire power connectors and connect it to the drive.

Figura 17. Connecting a serial ATA drive

What to do next:

vTo work with another option, go to the appropriate section.

vTo complete the installation, go to Capitolo 4, “Completing the parts replacement”, a pagina 31.

Installing a diskette drive in bay 3

To install a diskette drive in bay 3, do the following:

1.Remove the computer cover. See “Removing the cover” a pagina 9.

2.Access the system board. See “Accessing system board components and drives” a pagina 10.

3.Remove the metal shield from the diskette drive bay by using a flat-blade screwdriver to gently pry it loose.

4.Remove the plastic panel in the bezel by squeezing the plastic tabs that secure the panel on the inside of the bezel.

5.Install a retainer bracket on the side of the diskette drive.

Figura 18. Retaining bracket

6.Install the diskette drive into the bay from the front until it snaps into position.

Figura 19. Installing the diskette drive

18Hardware Installation and Replacement Guide

Image 26

Contents Page Page ThinkCentre Hardware Installation and Replacement Guide Page Indice Capitolo 2. OverviewIv Hardware Installation and Replacement Guide Lenovo 2005, 2007. Portions IBM Corp Vi Hardware Installation and Replacement Guide Capitolo 1. Important safety information Hardware Installation and Replacement Guide Handling static-sensitive devices Capitolo 2. OverviewAdditional information resources Figura 1. Controls and connectors LocationsLocating connectors on the rear of your computer Figura 2. Connector locationsLocating components Figura 3. Component locationsIdentifying parts on the system board Figura 4. System board parts locationsHardware Installation and Replacement Guide Tools required Capitolo 3. Installing options and replacing hardwareInstalling external options Removing the coverAccessing system board components and drives Figura 5. Sliding the coverInstalling internal options Installing memoryHardware Installation and Replacement Guide Installing PCI adapters What to do nextInstalling internal drives Figura 11. Opening the adapter latchDrive specifications Installing a drive in bay Connecting drives Installing a diskette drive in bay Replacing the battery Figura 20. Battery removalFigura 21. Battery installation Replacing the hard disk driveFigura 22. Removing the hard disk drive Replacing the diskette drive Figura 24. Removing the diskette driveFigura 26. Installing the new diskette drive Replacing an optical driveReplacing the heat sink and fan assembly Figura 28. Retaining bracket for optical driveFigura 30. Removing the heat sink Replacing the system fan assembly Figura 32. Removing the system fan assemblyReplacing a memory module Figura 33. Removing the memory moduleReplacing a PCI adapter Figura 35. Removing the adapterFigura 36. Installing the new adapter Replacing a keyboardFigura 38. Mouse connectors Replacing a mouseCapitolo 4. Completing the parts replacement Figura 39. Sliding on the coverObtaining device drivers Capitolo 5. Security features Integrated cable lockPadlock Password protectionErasing a lost or forgotten password clearing Cmos Capitolo 5. Security features Hardware Installation and Replacement Guide Appendice. Notices Television output notice TrademarksPage Numero parte 43C4818 Stampato in Italia