Lenovo RD230 manual Restore on AC, Power Loss

Table 31. Items under the Boot menu (continued)

Item	Sub-item	Option	Description
Hard Disk Drives	1st Drive		Based on the
	2nd Drive		installed hard disk
	...		drives.
CD/DVD Drives	1st Drive...		Based on the
			installed optical
			drives.

Note: The settings in [ ] are the default settings in the Setup Utility program.

Table 32. Items under the Security menu

	Item		Description
Change Supervisor Password			Set or change the supervisor password. The
			password can be any combination of up to 6
			(1 to 6) alphabetic and numeric characters.
Change User Password			Set or change the user password. The
			password can be any combination of up to 6
			(1 to 6) alphabetic and numeric characters.
Note: The settings in [ ] are the default settings in the Setup Utility program.
Table 33. Items under the Chipset menu
Item		Sub-item	Option	Description
CPU Bridge		QPI Frequency	[Auto]	Standard transferring
Configuration			4.800GT	rate of the QPI bus.
			5.866GT
			6.400GT
		QPI L0s and L1	Disabled	Enable or disable the
			[Enabled]	QPI L0s and L1.
		Memory Frequency	[Auto]	Set the frequency of
			Force DDR-800	the memory module.
			Force DDR-1066	Make sure that the
			Force DDR-1333	mandatory memory
				frequency setting is
				less than the
				maximum frequency
				that the memory
				module can support.
		Memory Mode	[Independent]	Set the memory
			Channel Mirroring	channel mode to
			Lockstep	improve reliability or
				efficiency.
South Bridge		Restore on AC Power	Power Off	If the power is
Configuration		Loss	Power On	recovered after
			[Last State]	outage, the system
				will be at the state
				that you set under
				Restore on AC
				Power Loss.

Note: The settings in [ ] are the default settings in the Setup Utility program.

Chapter 7. Configuring the server 111