JBL AVR 140 owner manual System and Power Connections, AC Power Connections, Watts, Command

Installation and Connections

Figure 1: SCART/Cinch-Adapter for playback; signal flow:

SCART → Cinch

Figure 2: SCART/Cinch-Adapter for record and playback; signal flow:

SCART ↔ Cinch

Figure 3: Cinch/SCART-Adapter for playback; signal flow:

Cinch → SCART

Black

Yellow

Red

Black

Red

Blue1

Yellow

Green1

White

Black

Yellow

Red

System and Power Connections

AC Power Connections

This unit is equipped with two accessory AC outlets. They may be used to power accessory devices, but they should not be used with high-current draw equipment such as power amplifiers. The total power draw to the Unswitched Outlet must not exceed 100 watts, that to the Switched Outlet

50 watts.

The Switched outlet will receive power only when the unit is on completely. This is recom- mended for devices that have no power switch or a mechanical power switch that may be left in the “ON” position.

NOTE: Many audio and video products go into a Standby mode when they are used with switched outlets, and cannot be fully turned on using the outlet alone without a remote control

Figure 4:

SCART/S-Video Adapter

for playback;

signal flow:

SCART → Cinch

Figure 5:

SCART/S-Video Adapter

for record and playback;

signal flow:

SCART ↔ Cinch

Figure 6:

SCART/S-Video Adapter

for playback;

signal flow:

Cinch → SCART

Red

Black

S-Video In

Black

Red

Blue1

Yellow

S-Video In

S-Video Out

Red

Black

S-Video Out

1Also other colours possible, e.g. brown and grey.

command.

The Unswitched outlet will receive power as long as the unit is plugged into a powered AC outlet and the Main Power Switch 1is on.

The AVR draws significantly more current than other household devices such as computers that use removable power cords. For that reason, it is important that only the cord supplied with the unit (or a direct replacement of identical capaci- ty) be used.

Once the power cord is connected, you are almost ready to enjoy the AVR 140’s incredible power and fidelity!

Important Note for the Use of

SCART-Cinch Adapters:

When video sources are connected to the TV directly with a SCART cable, specific control signals apart from Audio/Video signals will be fed to the TV. These specific signals are: With all video sources, the signal for automatic input selection that switches the TV automatically to the appropriate input as soon as the video source is started. And with DVD players, the signals automatically turning the TV to 4:3/16:9 format (with 16:9 TVs or with 4:3 TVs with selectable 16:9 format) and turning the RGB video decoder of the TV on or off, depending on the DVD player´s setting. With any adapter cable, these control signals will be lost and the appropriate setting of the TV must be made manually.

Note for RGB signal with SCART:

If you use a unit providing RGB signals on a SCART output (as e.g. most DVD players do) and you want to use that RGB signal, this SCART output must be connected directly to your TV. Although the AVR can switch three-way video signals (like component signals Y/Pb/Pr), most TVs need separate sync signals for RGB (also with SCART) that cannot be switched and pro- vided by the AVR.

RGB signals can be pathed through the AVR only when no separate sync signal is needed (see last ”Video Connection Note” on page 13).

14INSTALLATION AND CONNECTIONS