Maintenance and Cleaning
Lamp Replacement
When the projection lamp of the projector reaches its end of life, the Lamp replacement icon appears on the screen and LAMP REPLACE indicator lights yellow. Replace the lamp with a new one promptly. The timing when the LAMP REPLACE indicator should light is depending on the lamp mode.
WARNING:
TURN OFF THE UV LAMP BEFORE
OPENING THE LAMP COVER
✔Note:
•The Lamp replacement icon will not appear when the Display function is set to “Off” (p.46), during “Freeze” (p.25), or “No show” (p.26).
Indicators | LAMP REPLACE | |
indicator | ||
|
Lamp replacement icon
CAUTION
Allow a projector to cool for at least 45 minutes before you open the Lamp cover. The inside of the projector can become very hot.
CAUTION
For continued safety, replace with a lamp of the same type. Do not drop a lamp or touch a glass bulb! The glass can shatter and may cause injury.
Follow these steps to replace the lamp.
1
2
3
4 Replace the lamp with a new one and secure the two
(2)screws. Make sure that the lamp is set properly. Close the lamp cover and secure the screw.
5
6 Reset the lamp counter.
See “Lamp Replacement Counter” on the next page.
✔Note:
•When replacing the projection lamp, protect the infrared remote receiver with a soft cloth to avoid damaging it.
Lamp Cover
Screw
Screw Handle
Screw
Lamp
ORDER REPLACEMENT LAMP
Replacement lamp can be ordered through your dealer. When ordering a projection lamp, give the following information to the dealer.
● | Model No. of your projector | : |
● | Replacement Lamp Type No. | : |
|
| (Service Parts No. 610 337 9937) |
63