Sanyo PLC-XL51 owner manual Appendix, Image is out of focus

Appendix

	–  Adjust focus of the projector (see page 24).
	–  Provide proper distance between the projector and the projection screen
	(see page 14).
Image is out of focus.	–  Check the projection window to see if it needs cleaning (see page 62).
	–  Moving the projector from a cool to warm place may result in moisture
	condensation on the projection lens. If this occurs, leave the projector off
	and wait until condensation evaporates.
	–  Projecting from excessive slant angle to the screen may cause keystone
	distortion and partial imperfect focus.
	–  Check if “Contrast” or “Brightness” are adjusted properly. (See page 34,
	42)
Picture is not bright enough.	–  Check if “Image level” is selected properly. (See pages 32-33, 40-41)
	–  Check the Lamp control function. ( See “SETTING” section on page 51)
	–  Check the Lamp replace indicator. If it lights, the end of lamp life is
	approaching. Replace the lamp with a new one promptly. (See page 63)
The color is strange.	–  Check the Input signal, color system, video system, or computer system
	mode.
	–  Adjust the Image Level properly. See pages 32-33, 40-41.
Image is Left/Right reversed.	–  Check the Ceiling/Rear function (see page 49).
Image is Top/Bottom reversed	–  Check the Ceiling function (see page 49).
The image is distorted or runs off.	–  Check “PC Adjustment” menu or “Screen” menu and adjust them.
	–  Check the audio cable connection from audio input source.
	–  Adjust the audio source.
	–  Press the Volume + button (see page 25).
No sound	–  Press the Mute button (see page 25).
	– Is the image projected? You will hear the sound only when the
	image is projected.
	–  When the AUDIO OUT is plugged in, the projector’s built-in speaker is not
	available.

Auto PC adjustment function does not work.

–  Check the Input signal. Auto PC Adjustment function can not work when 480p, 575p, 720p, 480i, 575i, 1035i, or 1080i is selected. (See page 29)

Some displays are not seen during	–  Check the Display function (see page 46).
the operation.

The setting does not remain after turning off power.

–  Make sure you selected “Store” after adjusting settings. Some settings can not be stored if not registered with “Store”.

Power management function does	–  Power management function can not work while “Freeze” or “No Show”
not work.	function is running.
Image disappears automatically.	–  Check the power management function in the Setting. The power
	management is set to "On" at the factory.
Capture function does not work.	–  Check the connection and input signal to see if there is signal.

66