Sanyo PLC-XP200L owner manual Appendix

Appendix

– Filter is out of scroll. Replace the filter cartridge with a new one promptly. (See pages 62 -63)

appears on the screen
	– Adjust the focus of the projector.
	– Check Projection Lens to see if it needs cleaning.
	✔Note: Moving the projector from a cool temperature location to a warm temperature
The image is out of focus.	location may result in moisture condensation on Projection Lens. In such cases,
	leave the projector OFF and wait until condensation evaporates.
	–  Projecting from excessive slant angle to the screen may cause keystone distortion
	and partial imperfect focus.
	– Make sure the projection screen is at least 4.6’ (1.4 m) away from the projector.
	– Check if “Contrast” or “Brightness” are adjusted properly. (See page 49)
The image is not bright	– Check if “Image level” is selected properly. (See pages 42, 46)
	– Check the Lamp control function. ( See “SETTING” section on page 55)
enough.
	– Check the LAMP REPLACE indicator. If it lights, the end of lamp life is approaching.
	Replace the lamp with a new one promptly. (See page 64)
The color is strange.	– Check the Input signal, color system, video system, or computer system mode.
	– Adjust the Image Level properly. (See pages 42, 46)
The image is Left/Right	– Check the Ceiling / Rear function. (See pages 44, 48.)
reversed.
The image is Top/Bottom	– Check the Ceiling function. (See pages 44, 48.)
reversed.
The image is distorted or	– Check “PC Adjust” menu or “ Screen” menu and adjust them.
runs off.
Auto PC adjustment	– Check the Input signal. Auto PC Adjustment function cannot work when 480p, 575p,
	720p, 480i, 575i, 1035i, or 1080i is selected or when the digital signal is input into DVI
function does not work.
	terminal. (See page 39)
Some displays are not	– Check the Display function (see page 52).
seen during the operation.
The setting does not	– Make sure you selected “Store” after adjusting settings. Some settings cannot be
remain after turning off
	stored if not registered with “Store”.
power.
Power management	– Power management function cannot work while “Freeze” function is running or the
function does not work.	shutter is closed.
Image disappears	– Check the power management function in the Setting. The power management is set
automatically.	to "On" at the factory.
Capture function does not	– Check the connection to see if there is signal.
work.
Some menus cannot be	– Each of the Video Input and Computer Input has a limit on selectable menus.
selected.
	– Check the audio cable connection from audio input source.
	– Adjust the audio source.
No sound	– Press the Volume + button. ( See page 31)
	– Press the Mute button. (See page 31)
	– Is the image projected? You will hear the sound only when the image is projected.
	– Make sure you selected correct Input pattern. (See page 31)

70