Sanyo PLC-XP200L owner manual Projector is detecting abnormal condition, Lamp Replace

Appendix

The projector is detecting abnormal condition..

		Indicators						Projector Condition
POWER		LAMP/	WARNING		WARNING	LAMP
green		SHUTTER	TEMP.		FILTER	REPLACE
		red/blue		red	orange	orange
		❖			✽		✽	The temperature inside the projector is elevated close to the
								abnormally high level.
								The temperature inside the projector is abnormally high. The
								projector cannot be turned on. When the projector is cooled
		❖			✽		✽	down enough and the temperature returns to normal, the
								POWER indicator lights green and the projector can be turned
								on. (The WARNING TEMP. indicator keeps blinking.) Check and
								replace the filter.
								The projector has been cooled down enough and the
		❖			✽		✽	temperature returns to normal. When turning on the projector,
								the WARNING TEMP. indicator stops blinking. Check and
								replace the filter.
								The lamp cannot light up. (The projector is preparing for stand-
		❖			✽			by or the projection lamp is being cooled down. The projector
								cannot be turned on until cooling is completed.)
								The lamp cannot light up. (The lamp has been cooled down
		❖			✽			enough and the projector is in stand-by mode and ready to be
								turned on with the ON/STAND-BY button.)
								The lamp has been used overtime. Replace the lamp
	✽	✽		✽	✽			immediately and then reset the lamp counter. The indicator
								will be turned off after resetting the counter.

WARNING FILTER

When the filter detects clogging, reaches a time set in the timer setting or runs out of the filter scroll, the WARNING FILTER indicator lights orange. When this indicator lights orange, replace the filter or the filter cartridge with a new one promptly. Reset the Filter counter and Scroll counter after replacing the filter cartridge (p.63).

LAMP REPLACE

When the projection lamp reaches its end of life, the LAMP REPLACE indicator lights orange. When this indicator lights orange, replace the projection lamp with a new one promptly. Reset the lamp counter after replacing the lamp (p.65).

76