Sanyo PLC-XC56 owner manual Part Names and Functions, Rear Terminal, ⑤ LAN Connection Terminal

Part Names and Functions

Rear Terminal

		③	④	⑤	⑥
①	②

①CONTROL PORT

When the projector is controlled by a computer, connect to this jack with serial control cable.

②COMPUTER IN 1 / COMPONENT IN

Connect output signal from a computer, RGB scart 21-pin video output or component video output to this terminal (pp.14,16).

③MONITOR OUT

This terminal can be used to output the incoming analog RGB signal and component signal from COMPUTER IN 2 / DVI-I terminal or COMPUTER IN 1/COMPONENT IN terminal to the other monitor (pp.14,16).

④COMPUTER IN 2 / DVI-I

Connect computer output (Digital/Analog DVI-I type) to this terminal (p.14).

⑤LAN Connection Terminal

Connect the LAN cable (refer to the owner’s manual “Network Set-up and Operation”).

⑩ ⑨⑧ ⑦

⑥AUDIO OUT (VARIABLE)

Connect an external audio amplifier to this jack (pp.14-16).

This terminal outputs sound from AUDIO IN terminal (⑦ or ⑧).

⑦COMPUTER1 COMPONENT/ COMPUTER2 AUDIO IN

Connect the audio output (stereo) from a computer or video equipment connected to ② or ④ to this jack. (pp.14, 16)

⑧AUDIO IN

Connect the audio output signal from video equipment connected to ⑨ or ⑩ to this jack.

For a mono audio signal (a single audio jack), connect it to the L (MONO) jack (p.15).

⑨VIDEO IN

Connect the composite video output signal to this jack (p.15).

⑩S-VIDEO IN

Connect the S-VIDEO output signal from video equipment to this jack (p.15).