
Appendix
Troubleshooting
Before calling your dealer or service center for assistance, check the items below once again.
| Problem: | – Solutions |
|
|
|
|
|
No power.. | – Plug the power cord of the projector into the AC outlet. |
| |
|
| – See if the POWER indicator lights red. |
|
|
| – Wait until the POWER indicator stops blinking to turn on the projector |
|
|
| again. The projector can be turned on after the POWER indicator |
|
|
| turns red. See page 19. |
|
|
| – Check the WARNING indicator. If the WARNING indicator lights red, |
|
|
| projector cannot be turned on. See page 62. |
|
|
| – Check the projection lamp. See page 65. |
|
|
| – Unlock the Key lock function for the projector. See page 57. |
|
|
|
|
|
The initial display is not shown.. | – Make sure Off or Countdown off is not chosen at display function. |
| |
See page 47. |
| ||
|
|
| |
|
|
| |
The initial display is not same | – Make sure User or Off is not chosen at Logo (select) |
| |
as the default set.. | function. See page 48. |
| |
|
|
| |
Input signal switches automatically.. | – Make sure Input search function is adjusted properly. See page 46. |
| |
(or does not switch automatically) |
|
| |
|
|
| |
When the projector is on and you | – That is the Filter warning icon. See page 60. |
| |
press the input button, an icon |
|
| |
other than the Lamp mode icon |
|
| |
appears. |
|
| |
|
|
| |
An icon other than Input mode or | – That is the Lamp replacement icon or the Filter warning icon. See |
| |
Lamp mode icon appears.. | pages 60, 65. |
| |
|
|
| |
Image is out of focus.. | – Adjust focus of the projector. See page 24. |
| |
|
| – Provide proper distance between the projector and the projection |
|
|
| screen. See page 14. |
|
|
| – Check the projection lens to see if it needs cleaning. See page 64. |
|
|
| – Moving the projector from a cool to warm place may result in |
|
|
| moisture condensation on the projection lens. In such cases, leave |
|
|
| the projector off and wait until condensation evaporates. |
|
|
|
|
|
Image is Left/Right reversed.. | – Check the Ceiling/Rear function. See page 51. |
| |
Image is Top/Bottom reversed.. | – Check the Ceiling function. See page 51. |
| |
|
|
|
|
Picture is not bright enough.. | – Check if the Contrast or Brightness are adjusted properly. See |
| |
pages 36, 42. |
| ||
|
|
| |
|
| – Check if Image mode is selected properly. See pages 34, 41. |
|
|
| – Check the lamp control function. See pages 26, 56. |
|
|
| – Check the LAMP REPLACE indicator. If it lights, the end of lamp life |
|
|
| is approaching. Replace the lamp with a new one promptly. See page |
|
|
| 65. |
|
67