Sanyo PLC-SL20 Compliance, For Continental Europe For the U.K, For the U.S.A. and Canada

Compliance

Connecting the AC Power Cord

This projector uses nominal input voltages of 100-120 V or 200-240 V AC. This projector automatically selects the correct input voltage. It is designed to work with single-phase power systems having a grounded neutral conductor. To reduce risk of electrical shock, do not plug into any other type of power system.

Consult your authorized dealer or service station if you are not sure of the type of power being supplied.

Connect the projector with all peripheral equipment before turning the projector on. (See page 17-18 for connection.)

CAUTION

For safety, unplug AC power cord when the projector is not in use.

When this projector is connected to an outlet with AC power cord, it is in Stand-by mode and consumes a little electric power.

Connect AC power cord (supplied) to the projector. The AC outlet must be near this equipment and must be easily accessible.

NOTE ON THE POWER CORD

AC power cord must meet requirement of the country where you use a projector.

Confirm an AC plug type with the chart below and proper AC power cord must be used.

If supplied AC power cord does not match your AC outlet, contact your sales dealer.

Projector side			AC outlet side
	For the U.S.A. and Canada		For Continental Europe	For the U.K.
		Ground

To power cord connec- tor on your projector.

To the AC outlet.

(120 V AC)

To the AC outlet.

(200 - 240 V AC)

To the AC outlet.

(200 - 240 V AC)

7