Hitachi GR2000-B Series quick start Release 1.00 August, Change Record, Preface, GR2K-GA-0008

Page 3

Release 1.00 (August 2002)

This publication contains the most current information available to date. As new and revised sections are received, new updates will be distributed.

Notice: No part of this publication may be reproduced or transmitted in any form or by any means, electronic or mechanical, including photocopying and recording, or stored in a database or retrieval system for any purpose without the expressed written permission of Hitachi, Ltd.

Hitachi, Ltd. reserves the right to make changes to this document at any time without notice, and assumes no responsibility for its use. All the features described in this document may not be currently available.

Change Record

Revision

Date

Description

Affected

No.

Pages

 

 

 

 

 

 

1.00

August 2002

Initial Release

All

 

 

 

 

Preface

This manual presents simplified procedures for unpacking, setup and operating the GR2000-B models. Before you begin to unpack and use the GR2000-B, read the “Safety” pages at the beginning of this manual, which gives you directions necessary to handle the GR2000 safely.

Information contained in this manual is subject to change without prior notice.

GR2K-GA-0008

iii

Rev. 1.00

 

Image 3
Contents Hitachi Gigabit Router GR2000-B Series Rev Hitachi Gigabit Router GR2000-B Series Quick Start GuideGR2K-GA-0008 Release 1.00 AugustChange Record PrefaceAbbreviations GR2K-GA-0008 Rev IlmiLEC PIM Viii Safety Guide General Safety GuidelinesDamage to the equipment or a disruption in service Specific Warning Instructions Specific Caution Instructions Xii CleaningOther Instructions StorageTable of Contents Display of Operation Status XivDocumentation for the GR2000-B Series List of FiguresXvi List of Tables Xviii Documents about the GR2000-B models Chapter IntroductionDocumentation for the GR2000-B Series GR2K-GA-0008 Rev Chapter Setup Process Assemble the Required Tools for SetupCheck that All Necessary Components are Present GR2000-1B Setting Up the GR2000-B2 GR2000-2B Setup ProcessGR2000-2B Rear View GR2K-GA-0008 Rev Front panel indicators To yourself and the routerDue to static electricity Attaching the Rubber Feet Installing the GR2000-B on a Table or DeskConnecting a Power Cable to the GR2000-B Attaching and Detaching the Power CableInstalling a Memory Card Installing a Memory Card10 After Installation of a Memory Card Permanently damage the memory card SoftwareSpecifications Required for Setup Terminals Setup Terminal and Cable ConnectionsSetup Terminal Connecting CableConnecting the GR2000-B to Other Devices Connecting a Setup Terminal to the GR2000-BNormal Start-Up Process for the GR2000-B Turning the Power Switch onTurning the Power OFF Memory card, then power it on againThis page left intentionally blank Chapter Basic Operations Configuration ExamplesStartup of the GR2000-B First-Time LoginSetting the Time Set a password with passwd commandSetting the Configuration Enter the Administrator ModeBasic Operations Open the Configuration File Set a Default RouteSet an IP Address for the Ethernet Port Return to the Administrator Mode Close the Configuration FileManuals of the GR2000 Display of the Operation Status Covering the Entire Router Display of Operation StatusDisplay of the Operation Status of the Interface Configured Display of the Operation Status of the Built-In EthernetDisplay of the Routing Table More Details About Operation Details About Other SettingsThis page left intentionally blank Types of Trouble and Corrective Action Chapter TroubleshootingTroubleshooting and Reference manuals More Details About TroubleshootingTroubleshooting