Hitachi GR2000-B Series Setting the Configuration, Enter the Administrator Mode, Basic Operations

Basic Operations

3.3Setting the Configuration

This section explains about how to configure the GR2000-B for operation.

!￿HQDEOH￿		(1) The system enters the administrator mode.
￿￿FRQILJXUH￿		(2) The system enters the configuration edit mode.
￿FRQILJ￿￿￿RSHQ		(3) The configuration file is opened.
￿FRQILJ￿￿￿OLQH￿/$1￿￿HWKHUQHW￿￿￿￿		(4) IP address is set for the Ethernet port.
￿￿FRQILJ￿￿￿OLQH￿/$1￿￿HWKHUQHW￿￿￿￿￿
￿￿FRQILJ￿￿￿LS￿/$1￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿		(5) A default route is set.
￿￿FRQILJ￿￿￿LS￿/$1￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿
￿￿FRQILJ￿￿￿VWDWLF￿GHIDXOW￿JDWHZD\￿￿￿￿￿￿￿￿￿￿￿￿		(6) The information configured is dispayed.
￿￿FRQILJ￿￿￿VKRZ
OLQH￿/$1￿￿HWKHUQHW￿￿￿￿￿
OLQH￿/$1￿￿HWKHUQHW￿￿￿￿￿
LS￿/$1￿￿^			The information displayed as a
￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿
`￿￿			result of the configuration.
LS￿/$1￿￿^
￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿
`￿
VWDWLF￿^
￿￿￿￿￿￿￿￿GHIDXOW￿JDWHZD\￿￿￿￿￿￿￿￿￿￿￿￿￿￿
`￿	(7) The configuration information is saved.
￿￿FRQILJ￿￿￿VDYH	(8) The configuration file is closed.
￿FRQILJ￿￿￿FORVH￿
	(9) The system goes out of the configuration edit mode.
￿FRQILJ￿￿￿H[LW￿
	(10) The system goes out of the administrator mode.
￿￿H[LW
!

Here is some detailed information about the each of the settings.

3.3.1Enter the Administrator Mode

!￿HQDEOH	The system is switched to the
	administrator mode by the
￿	enable command.
	The # prompt is used in the
	administrator mode.

3.3.2Enter the Configuration Edit Mode (Begin Editing the Configuration)

!￿FRQILJXUH	The system is switched to the
	configuration edit mode by the
￿FRQILJ￿￿	configure command.
	The (config)# prompt is shown.

GR2K-GA-0008	3-3
Rev. 1.00