Hitachi CP-X267 user manual Troubleshooting

6.. Troubleshooting

6. Troubleshooting

	Problem		Likely Cause	Things to Check	Reference
					Page
					Number
			The projector is not turned	Is the projector’s lamp on?	*16
			on.
No image
			The projector’s input source	Is the projector switched to	*17
			isn’t switched to MIU.	MIU?
				Check both the PC and
				projector’s network settings.
				If you change the projector’
				s settings, turn off the
		The projector	The PC and/or projector’s	projector’s AC power and	10
		that you want	network settings are not	then turn it on again. If you
		to connect to	configured correctly.	simply put the projector in
		is nowhere		STANDBY power mode and
		to be found		then turn it on again, the
		on the list		new settings might not take
Wireless/Wired	LiveMode	of available		effect.
		projectors		• Bring the PC and projector
			Weak radio signal	closer together	–
				• Radio waves won’t go
				through concrete and
				metal (steel doors, etc.)
		Can't	The Projector isn’t in Live	Check the mode on MIU	53
				Menu to make sure that it is
		communicate	Mode
				in the correct mode.
			The projector isn’t capable	Try increasing the Capture
		The projected	of relaying dynamic images	Performance priority level.	58
		image is	such as PowerPoint®	It may improve the speed a
		rather slow	animation at full speed.	little.
		compared to	“Optimize Performance” is	Try setting “Optimize	58
		that of the PC		Performance” to
			set to “Image quality”.	“Transmission speed”.
(continued on next page)			* User’s Manual (detailed) - Operating Guide

116