3..Using the Live Mode
3.4Passcode connection (continued)
The projector connected to an access point by a LAN cable
1)The setting on the access point. *1 Enter the following information.
SSID : WirelessAccessPoint (example)
Encryption: WEP64bit (example)
Encryption key *2: ********** (example)
2)The setting on the projector. *3 Enter the following information.
Subnet mask *4: 255.255.255.128 (example)
3)Click [Connect].
4)The wireless connection will be established.
Proceed to the item 3.6 Confirm the connection to your destination. (50)
*1 Contact the network administrator to find out the setting on the access point. *2 If you use an encryption, you need to set it. Contact the network administrator
to check the encryption key that is set in the projector. The encryption key is always shown as “**********”.
*3 To find the network setting on the projector, refer to the NOTE. (40)
*4 If you use Subnet mask except Class A/B/C, please set it.
38