3..Using the Live Mode
3.5Manual configuration (continued)
The projector connected to an access point by the wireless LAN
1)The setting on the access point. *1 Enter the following information.
SSID: WirelessAccessPoint (example)
Encryption: WEP64bit (example)
Encryption key *2: ********** (example)
Mode: INFRASTRUCTURE
2)Click [Next].
3)Enter the following information that is set in the projector. *3
IP Address : 192.168.1.10 (example)
Subnet mask: 255.255.255.0 (example)
4)Click [Connect].
5)The wireless connection will be established.
Proceed to the item 3.6 Confirm the connection to your destination. (50)
*1 Contact the network administrator to find out the setting on the access point. *2 If you use an encryption, you need to set it. Contact the network administrator
to check the encryption key that is set in the projector. The encryption key is always shown as “**********”.
*3 To find the network setting on the projector, refer to the NOTE. (40)
46