Hitachi SJ-DG Timing AT TWO Dividing Data Input, Timing chart of two dividing data input

Page 19

CHAPTER 5 FUNCTION

5.3.2 TIMING AT TWO DIVIDING DATA INPUT

Take in data in on-edge of strove signal. Let on/off time of strobe signal be more than 20ms. And let off time of strobe signal be more than 20ms,

Data definite

period

Data definite

period

Data definite

period

Dn

Normal data

Abnormal data

Normal data

(n=0-15)

 

 

 

More than 0ms

More than 0ms

More than 0ms

STRB

ON

ON

ON

 

 

 

OFF

OFF

OFF

OFF

More than

 

More than

More than

 

20ms

 

20ms

20ms

SEQ

(Sequence error output)

OFF

Within 20ms

More than

More than

20ms

20ms

ON

 

OFF

Within 20ms

At load current 20mA

Figure 5.3.2 Timing chart of two dividing data input

Precaution If Figure 5.3.2 timing chart is not satisfied, be careful because of possibility of taking in error data.

5.4 NOTICE AT DATA INPUT

While inputting the data by terminal of SJ-DG, notice the following items.

(1)Each input is possible to set within data range of the inverter in every setting item. If inputting without data range, sequence error is outputted and data input is invalid (previous data is kept).

(2)If classification code is inputted in dividing input mode, make sure to input classification code in order, higher code, and then lower code. If lower code is inputted at first, sequence error is outputted and data input is invalid (previous data is kept)

(3)Re-input of correct data, or reset of inverter, or power off carries out cancellation of sequence error. And, if two times input are correct in dividing input mode, they are cancelled just after second input.

(4)If a code without codes in table of classification is inputted, sequence error is outputted.

(5)In case of trip of inverter, data input is invalid. Make sure to reset inverter and re-input.

(6)When each command destination of inverter is not set to option board put on, do not input data.

(7)If setting frequency is input in “rate”, do the following process below.

(Example) If 75% of max frequency is set, input I in is

I in = 0.75 × M

0.75 ￿ rate

 

 

M ￿input data full scale

 

Switch type 1

Input data full scale value( M )

 

 

 

 

BIN

65535

13

Image 19
Contents SJ300/L300P Series Hitachi InverterRevision History Table Safety Precautions Otherwise, there is a danger of fire Otherwise, there is a danger of connecting errorOtherwise, there is a danger of electric shock and/or fire Otherwise, there is a danger of electric shockSafety Precautions Page Outline of the Product Inquiry of the Product and Warranty for the ProductWarranty of the Product Inspection Upon UnpackingInstallation of option printed board Installation Method of Printed BoardPlcb Terminal Assignment of Digital Input Option BoardConnection to Programable Controller Case of using external power sourceApplicable Wiring Specification of TerminalSpecification of terminal Input Mode by DIP Switch and Rotary Switch Position of Setting SwitchInitial Setting Condition of Printed Board Setting of InverterType Code BCD DIV Table of input modeOFF Type Code BIN PACPrecautions AT Setting of Switch BIN PAC FunctionONE Time Binary Input ONE Time BCD InputBIN DIV TWO Dividing Binary InputBCD DIV TWO Dividing BCD InputTable of classification code Classification CodeData Input Timing Timing AT ONE Time Input MO DETiming AT TWO Dividing Data Input 2 Timing chart of two dividing data inputBCD