Hitachi CPX430W user manual Troubleshooting, OSD Messages, Message Contents

Page 21

TROUBLESHOOTING

OSD Message

The messages as described below may appear on the screen at power ON. Take the appropriate measures when such messages appears.

Table 9. OSD Messages

Message

Contents

 

 

CHANGE THE LAMP

The usage time of lamp will be reaching 2000 hr

AFTER REPLACING LAMP,

shortly.(*2)

RESET THE LAMP TIME.

It is recommended to replace the lamp soon. Prepare a

(*1)

new lamp as a replacement.

 

 

 

The usage time of lamp will be reaching 2000 hr shortly.

CHANGE THE LAMP

It is recommended to replace the lamp within * *

AFTER REPLACING LAMP,

hours.(*2)

RESET THE LAMP TIME.

It might be happened that the lamp is cut off before * * hr

THE POWER WILL TURN OFF

by any chance. Power will be switched OFF

AFTER ** hr.

automatically in * * hours. Replace the lamp as shown in

(*1)

P.17~18 “Lamp”. Always reset the lamp timer after

 

replacing the lamp.

 

 

CHANGE THE LAMP

The usage time of lamp is about to reach. Power will be

AFTER REPLACING LAMP,

switched OFF in a few minutes.(*2)

RESET THE LAMP TIME.

Switch power OFF immediately and replace the lamp as

THE POWER WILL

shown in P.17 ~18 “Lamp”. Always reset the lamp timer

TURN OFF

after replacing the lamp.

AFTER 0 hr.

 

 

 

NO INPUT IS DETECTED

No input signal found.

ON ***

Check signal input connections and signal sources.

 

 

 

The horizontal or vertical frequency of the input signal is

SYNC IS OUT OF RANGE

not within the specified range.

ON ***

Check the specifications of the equipment and the signal

 

source.

 

 

NOTE (*1) This message is cleared automatically after approximately three minutes, and appears every time power is switched ON.

(*2) The unit has a function to turn the power off which will be active when the usage time reaches 2000 hr. However the life of lamp might be much different among lamps, so that it might be happened that a lamp is cut off before the function is active.

ENGLISH-20

Image 21
Contents CPX430W Contents Features Contents of PackageBefore USE Before USE Part NamesComponent Video Refer to P.9 Operations TransmitterLoading the Batteries Installation of the Projector and Screen InstallationAngle Adjustment Installation ReferenceInstallation CablingCabling Power Connection Example of system setupPlug & Play Power OFF Power onOperations StandbyOperations Basic OperationBasic Operation Description Normal menu Setup Menu Setup MenuAutomatic Adjustment at Video Input Select the Execute with Automatic Adjustment at RGB Input Select the Execute withInput Menu Input MenuImage Menu Description Image MenuStart UP MirrorOptions Menu Options MenuSelect Menu Background Color Select with Select Menu Display Language Select withNo Signal Menu No Signal Menu DescriptionReduce Increase Lamp MaintenanceLamp Lamp LifeMaintenance Resetting the Lamp TimerReplacing the Lamp Air Filter Other MaintenanceMessage Contents TroubleshootingOSD Message OSD MessagesIndicators Message TroubleshootingIndicators Message IndicatorSymptom SymptomSymptom Possible cause Remedy Specifications SpecificationsWarranty and AFTER-SERVICE Dimension Diagram Signal Connector Pin AssignmentTechnical Technical Example of computer signalInitial set signals PS/2, ADB or Serial Mouse Connection to the Mouse ControlUSB Mouse PS/2 MouseSerial Mouse ADB MouseCommand data Communications settingRS-232C communication ProtocolChanging the projector settings Set command Requesting projector status Get commandUsing the projector default settings Reset Command Increasing the projector setting value Increment commandCRC Be EF BA D2 Be EF FD D3 Be EF Ntsc PAL Be EF CB D0 Regulatory Notices FCC Statement WarningFor the Customers in Canada Pour les utilisateurs au Canada Page Hitachi Atago Building