Hitachi 8000 Elite manual Enww

Page 29

9.Store the removed card in anti-static packaging.

10.If you are not installing a new expansion card, install an expansion slot cover to close the open slot.

CAUTION: After removing an expansion card, you must replace it with a new card or expansion slot cover for proper cooling of internal components during operation.

11.To install a new expansion card, slide the bracket on the end of the card down into the slot on the back of the chassis and press the card down firmly into the socket on the system board.

Figure 2-14Installing an Expansion Card

NOTE: When installing an expansion card, press firmly on the card so that the whole connector seats properly in the expansion card slot.

12.Close the expansion card retention latch, making sure that it snaps firmly into place.

13.Connect external cables to the installed card, if needed. Connect internal cables to the system board, if needed.

14.Replace the computer access panel.

15.Reconnect the power cord and turn on the computer.

16.Lock any security devices that were disengaged when the computer access panel was removed.

17.Reconfigure the computer, if necessary.

ENWW

Removing or Installing an Expansion Card 23

Image 29
Contents Hardware Reference Guide Hardware Reference Guide About This Book Iv About This Book Table of contents Appendix D Electrostatic Discharge Standard Configuration Features Product Features1Front Panel Components Front Panel Components2Media Card Reader Components Media Card Reader Components3Rear Panel Components Rear Panel ComponentsKeyboard Using the Windows Logo Key4Keyboard Components 5Windows Logo Key FunctionsArrow 6Serial Number and Product ID Location Serial Number LocationServiceability Features Hardware UpgradesSmart Cover FailSafe Key Unlocking the Smart Cover Lock1Removing the Smart Cover Lock Screws Removing the Computer Access Panel 3Replacing the Computer Access Panel Hardware Upgrades Replacing the Computer Access PanelRemoving the Front Bezel Removing Bezel Blanks 6Replacing the Front Bezel Replacing the Front BezelDDR3-SDRAM DIMMs Installing Additional MemoryDIMMs 1DIMM Socket Locations Populating Dimm SocketsInstalling DIMMs Enww 2Expansion Slot Locations Removing or Installing an Expansion Card11Removing an Expansion Slot Cover Enww Enww 3Drive Positions Drive PositionsRemoving a Drive from a Drive Bay 16Disconnecting the Optical Drive Cables17Disconnecting the Media Card Reader USB Cable Enww Enww Guide Screw Device Installing Additional Drives4System Board Drive Connections System Board Drive ConnectionsInstalling a 5.25-inch Drive into an External Drive Bay Enww 27Installing a Hard Drive into the Hard Drive Bay Removing and Replacing a Removable 3.5-inch Sata Hard Drive 30Removing the Thermal Sensor Enww Enww Enww Changing from a Minitower to a Desktop Configuration Enww Changing from a Desktop to a Minitower Configuration Enww Enww Table A-1Specifications SpecificationsPower Output Battery Replacement Type Enww HP/Kensington MicroSaver Security Cable Lock Installing a Security LockExternal Security Devices HP Business PC Security Lock PadlockEnww Figure C-6Engaging the Lock Front Bezel SecurityEnww Grounding Methods Electrostatic DischargePreventing Electrostatic Damage Computer Operating Guidelines and Routine Care Cleaning Optical Drive PrecautionsSafety Shipping PreparationIndex Enww