Hitachi 8000 Elite manual Enww

Page 38

CAUTION: The bottom 5.25-inch drive bay has a shorter depth than the upper two bays. The bottom bay supports a half-height drive or other device that is no more than 14.5 cm (5.7 inches) in depth. Do not try to force a larger drive, such as an optical drive, into the bottom bay. This could cause damage to the drive and the system board. The use of unnecessary force when installing any drive into the drive bay may result in damage to the drive.

9.Connect the power cable (1) and data cable (2) to the rear of the drive. Figure 2-25Connecting the Drive Cables (Optical Drive shown)

10.If you are installing a new drive, connect the opposite end of the data cable to the appropriate system board connector.

NOTE: If you are installing a SATA optical drive, connect the first optical drive to the white SATA connector on the system board labeled SATA1. Connect a second optical drive to the next available (unpopulated) SATA connector following the numbered sequence of the connectors.

If your are installing a media card reader, connect the USB cable to the USB system board connector labeled MEDIA. If the media card reader includes a 1394 port, connect the 1394 cable to the 1394 PCI card.

Refer to System Board Drive Connections on page 30 for an illustration of the system board drive connectors.

11.Replace the front bezel and computer access panel.

12.Reconnect the power cord and turn on the computer.

13.Lock any security devices that were disengaged when the computer access panel was removed.

14.Reconfigure the computer, if necessary.

Installing a 3.5-inch SATA Hard Drive into an Internal Drive Bay

NOTE: The system does not support Parallel ATA (PATA) hard drives.

Before you remove the old hard drive, be sure to back up the data from the old hard drive so that you can transfer the data to the new hard drive.

To install a hard drive in a 3.5-inch internal drive bay:

1.Remove/disengage any security devices that prohibit opening the computer.

2.Remove all removable media, such as compact discs or USB flash drives, from the computer.

32 Chapter 2 Hardware Upgrades

ENWW

Page 37 Page 39
Image 38
Page 37 Page 39
Contents Hardware Reference Guide Hardware Reference Guide About This Book Iv About This Book Table of contents Appendix D Electrostatic Discharge Product Features Standard Configuration FeaturesFront Panel Components 1Front Panel ComponentsMedia Card Reader Components 2Media Card Reader ComponentsRear Panel Components 3Rear Panel Components4Keyboard Components Using the Windows Logo KeyKeyboard 5Windows Logo Key FunctionsArrow Serial Number Location 6Serial Number and Product ID LocationHardware Upgrades Serviceability FeaturesUnlocking the Smart Cover Lock Smart Cover FailSafe Key1Removing the Smart Cover Lock Screws Removing the Computer Access Panel Replacing the Computer Access Panel 3Replacing the Computer Access Panel Hardware UpgradesRemoving the Front Bezel Removing Bezel Blanks Replacing the Front Bezel 6Replacing the Front BezelDDR3-SDRAM DIMMs Installing Additional MemoryDIMMs Populating Dimm Sockets 1DIMM Socket LocationsInstalling DIMMs Enww Removing or Installing an Expansion Card 2Expansion Slot Locations11Removing an Expansion Slot Cover Enww Enww Drive Positions 3Drive Positions16Disconnecting the Optical Drive Cables Removing a Drive from a Drive Bay17Disconnecting the Media Card Reader USB Cable Enww Enww Installing Additional Drives Guide Screw DeviceSystem Board Drive Connections 4System Board Drive ConnectionsInstalling a 5.25-inch Drive into an External Drive Bay Enww 27Installing a Hard Drive into the Hard Drive Bay Removing and Replacing a Removable 3.5-inch Sata Hard Drive 30Removing the Thermal Sensor Enww Enww Enww Changing from a Minitower to a Desktop Configuration Enww Changing from a Desktop to a Minitower Configuration Enww Enww Specifications Table A-1SpecificationsPower Output Battery Replacement Type Enww HP/Kensington MicroSaver Security Cable Lock Installing a Security LockExternal Security Devices Padlock HP Business PC Security LockEnww Front Bezel Security Figure C-6Engaging the LockEnww Grounding Methods Electrostatic DischargePreventing Electrostatic Damage Computer Operating Guidelines and Routine Care Safety Optical Drive PrecautionsCleaning Shipping PreparationIndex Enww
Top Page Image Contents