5RGB Input 2 Connector (Mini D-Sub 15 pin)
Connect a Macintosh or compatible computer here using the signal cable and the monitor adapter that is supplied. Or connect your PC or other RGB equipment such as IBM or compatible computers. Use the signal cable that is supplied to connect to a PC.
RGB 2 Audio Input Mini Jack
This is where you connect a second RGB audio output from a computer or another RGB source.
6PC Control Port
Use this port to connect your PC to control the MultiSync MT830/1030 Projector. This enables you to use your PC and serial communication protocol to control the projector. If you are writing your own program, command references are on page
A cap is put on the port at the factory. Remove the cap when using the port.
7Mouse Output Port
Use this port to operate your computer’s mouse functions from the NEC MultiSync MT830/1030 remote control. When your computer is connected here, the remote sensors on the LCD projector cabinet will receive your mouse com- mands.
8Remote Control Jack
Connect your remote control cable here for wired operation.
9Built-in Security Slot ( 
)
This security slot supports the MicroSaver® Security Sys- tem.
MicroSaver® is a registered trademark of Kensington
Microware Inc. The logo 
is trademarked and owned by Kensington Microware Inc.
6 7 8
S – VIDEO | INPUT | AUDIO |
|
| PC CONTROL MOUSE OUTPUT | REMOTE |
RGB MONITOR OUTPUT | AUDIO |
| CONTROL | |||
|
|
|
| INPUT | ||
| L/MONO | R |
|
| ||
|
|
|
| |||
|
|
| RGB INPUT 1 | AUDIO | RGB INPUT 2 | AUDIO |
| L/MONO | R |
|
|
| |
VIDEO | INPUT | AUDIO |
|
|
|
|
5
AC IN
9