5TROUBLESHOOTING
This section helps you resolve problems you may encounter while setting up or using your MultiSync MT830/1030 LCD Projector.
Status Light Messages
Condition | Status |
|
|
OFF | ⬛ Normal |
|
|
On continually | ⬛ The projector lamp has exceeded 2000 hours of operation and |
| should be replaced. |
|
|
Blinking very rapidly | ⬛ Either the lamp cover or filter cover is not fastened properly. Check |
(On and off in a cycle of 1 sec.) | each and reattach them if necessary. |
|
|
Blinking slowly | ⬛ The cooling fan has stopped. Contact your NEC dealer for service. |
(On and off in a cycle of 8 sec.) |
|
|
|
Blinking very slowly | ⬛ The lamp is not turned on. |
(On and off in a cycle of 12 sec.) | • The projector was turned off and back on too quickly. Turn |
| off the projector, wait one minute, then turn the projector |
| back on. Or the lamp is burnt out. |
|
|