NEC 5800/320Fd Removing the Cabinet from the Pallet, Sliding Back the Wooden Restraint Blocks

Page 19

Figure 11. Sliding Back the Wooden Restraint Blocks

msys102

14.Move the lever bar to the opposite side of the cabinet. Repeat the process of tilting the cabinet and sliding back the two wooden restraint blocks on the opposite side of the cabinet.

Removing the Cabinet from the Pallet

1.Position the pallet ramp under the pallet, at the rear of the cabinet (see Figure 12). Verify that it is secure.

-15-

Image 19

Contents NEC Corporation of America Read Me First Unpacking Express5800/320Fd System CabinetsPage Contents Page Packaged Cabinet IntroductionCabinet Packaged for Shipping Tie-down Ramp Before Unpacking the Cabinet Shows the dimensions of a packaged 38U cabinetDimensions of a Packaged 38U Cabinet Dimensions of a Packaged 24U Cabinet 56.5 Moving the Cabinet to the Installation Site To unpack the cabinet Unpacking and Checking the CabinetRemoving the Packing Materials Tools Needed to Unpack the CabinetCutting the Exterior Shipping Straps Remove the plastic wrap encasing the cabinet Removing the Interior Shipping Straps Wooden-Restraint Blocks Inserting the Lever Bar Tilting the Cabinet Sliding Back the Wooden Restraint Blocks Removing the Cabinet from the PalletPosition the Pallet Ramp Moving the Cabinet Down the Pallet Ramp Checking the Cabinet and SystemsVerifying the Express5800/320Fd Serial Number Stabilization Guidelines Stabilizing the SystemsWhat Happens Next? Disposing of Shipping MaterialsSystem Documentation Online support from NEC Technical Support. You Getting Help