4.When Head cleaning... disappears from the LCD panel, perform the nozzle check to confirm that the head is clean and to reset the cleaning cycle. See “Checking the Print Head Nozzles” on page 77.
Note:
❏If the print quality has not improved after repeating this procedure four or five times, turn this product off and leave it alone overnight. Then, perform the nozzle check again and repeat head cleaning if necessary.
❏If the print quality still has not improved, one or both of your ink cartridges may be old or damaged and may need to be replaced. To replace an ink cartridge, see “Replacing an Ink Cartridge” on page 72.
❏To maintain good print quality, we recommend printing a few pages at least once every month.
Aligning the Print Head
If you notice vertical lines are not aligned properly on the nozzle check result, you may be able to solve this problem by aligning the print head.
Follow the steps below to align the print head using the Control Panel.
Note:
Do not press the y Stop button to cancel printing while printing an alignment pattern.
1.Make sure that A4 or Letter paper is loaded in the sheet feeder.
2.Make sure that this product is on, and the ! Error light is off.
3.Press the Setup Mode button to enter the Setup Mode.