Epson PowerLite Home Cinema 3020, HC3020, 3020E manual Using Picture-in-Picture

If you have connected a television or other display to the output port on the transmitter and want to switch between wired and wireless display modes, press the Output button on the remote control or transmitter.

Remote control WirelessHD Transmitter

Note: The WiHD light on the transmitter will light up when the wireless display mode is active.

Using Picture-in-Picture

If you’ve connected multiple video sources to the WirelessHD Transmitter, you can use the Picture-in-Picture (P-in-P) feature to wirelessly project images from two separate video sources at the same time.

Make sure the video sources you want to project from are turned on, then follow these steps:

1.Press the P-in-Pbutton on the remote control to enable P-in-P projection.

2.Do the following to control the P-in-P display:

■Press the Input button on the remote control or the WirelessHD Transmitter to change the video source displayed in the sub-screen. Keep pressing the button to cycle through all of the connected video devices.

■Press the Output button to change the position of the sub-screen. The screen moves counter-clockwise from corner to corner each time the Output button is pressed.

64 Using WirelessHD