NEC 2000 IPS Internal Zone Paging with Meet-Me, IP Enabled Dterm, Last Number Redial, Maid Status

Chapter 9 Feature Descriptions

Manual Intercom

The Manual Intercom groups have up to six Multiline Terminals sharing a common signal path. Users can call other members of the Manual Intercom group by pressing a Manual Intercom key; each press sends a tone burst over the speakers of all the terminals in the group. When another user answers the call, a speech path is activated.

Automatic Intercom

Automatic Intercom provides a path for Voice Announcement Calls with Handsfree Answerback between two Multiline Terminals using a line key. Private conversations can be held by using the Multiline Terminal handsets. The Busy/Idle status of the associated Multiline Terminal is displayed on the Automatic Intercom line key LED.

Dial Intercom

Dial Intercom comprises up to 10 Multiline Terminals which can call each other using a dedicated Dial Intercom line key with abbreviated dialing. Dial Intercom calls can be Voice Announce with Handsfree Answerback or ringing calls.

Internal Tone/Voice Signaling Multiline Terminals can signal incoming internal calls by Voice Announcement or by ringing according to the programmed mode (Voice first or Ring first) of the called terminal. The caller can dial the digit 1 to change from Voice Announcement to Ring Tone or vice versa. The Multiline Terminal assigned this feature can program the following two modes:

•Voice Mode: allows an incoming call to terminate with Voice Announcement.

•Tone Mode: allows an incoming call to terminate with ringing.

Internal Zone Paging with Meet-Me

This feature allows the Attendant Console and system users to page over the built-in speakers of the Multiline Terminals within the assigned zone or all zones.

IP Enabled Dterm

This feature provides a Dterm Series E/i Terminal combined with an IP Adapter unit with the capability to connect UNIVERGE NEAX 2000 IPS via IP networking (IP Enabled Dterm). The IP Enabled Dterm provides users with all features currently available in Dterm Series E terminals.

Last Number Redial

This feature allows users to redial the last station-to-station or outside number they dialed using a feature access key or a feature access code. This is useful when the called station is busy or does not answer.

Least Cost Routing - 3/6 Digit

This service feature allows the UNIVERGE NEAX 2000 IPS to be programmed to route outgoing calls over the most economical facility (WATS, FX, DDD). Based on the individual area code and office code dialed (6- digit analysis), the system examines the programmed tables and uses the trunk in the order specified.

Line Lockout

This feature automatically releases a station from the common equipment if the station remains off-hook for longer than a programmed interval before dialing. Howler tone may be programmed to be sent to the station in Line Lockout.

Line Pre-selection

This feature provides the station user with two ways to select an idle, held, recalling, or ringing

line before going off-hook.

Maid Status

This feature allows the Hotel/Motel (H/M) Front Desk Instrument, Property Management System (PMS) terminal, or guest room station (using special access code) to register the condition of each guest room.

Page 9- 22	UNIVERGE NEAX 2000 IPS Request for Proposal (RFP) Reference Guide
	Issue 6