NEC NEAX2000 IVS2 system manual Purpose, Outline of this Manual

Page 8

INTRODUCTION

Purpose

INTRODUCTION

PURPOSE

This manual describes the hardware installation and programming procedure for the Q-SIG System on the NEAX2000 IVS2.

OUTLINE OF THIS MANUAL

This manual consists of the following chapters:

CHAPTER 1 GENERAL INFORMATION

This chapter explains the Q-SIG system outline, system configuration, the name and functions of circuit cards required, system capacity, system conditions, and available service features.

CHAPTER 2 INSTALLATION

This chapter explains the hardware installation procedure to provide Q-SIG interface on the PBX.

CHAPTER 3 SYSTEM DATA PROGRAMMING

This chapter explains the programming procedure to provide Q-SIG feature on the PBX.

CHAPTER 4 CIRCUIT CARD INFORMATION

This chapter explains the mounting location, the meaning of lamp indications, and the method of switch settings of each circuit card for the Q-SIG.

NEAX2000 IVS2 Q-SIG System Manual	Page 1
ND-70923 (E), Issue 1.0

Image 8

Contents SIG System Manual Liability Disclaimer NEAX2000 IVS2 NEAX2000 IVS2 Table of Contents List of Figures List of Tables Purpose Outline of this ManualReference Manuals Chapter General Information System Outline SummaryPhysical Interface 30DTI Physical Interface 24DTIInterworking with Other Network SIGSystem Configuration Clock30DTI PLO Card Name and Function Card Name FunctionalSystem Capacity Description 24DTI 30DTISystem Conditions Time Slot Assignment ConditionTime Slot Allocation for DTI/DCH Card Time Slot Allocation for DTIService Features Connected Destination IndicationTerm Transit Counter Relaying 10 Transit CounterChapter Installation When Holding a Circuit Card PrecautionsWhen PLUGGING/UNPLUGGING a Circuit Card When Making a Switch Setting on a Circuit Card When Carrying a Circuit CardInstallation Required Equipment Equipment Description Quantity RemarksPN-30DTC-A PN-24DTA-CInstallation Procedure Installation Procedure for Q-SIGMounting DTI and DCH Card Mounting Conn Card Selection of PLO in MP Card DTI Cable Connection via MDF Cable Connection via MDFLocation of the AP Slots and the LTC Connectors for DTI Example of MDF Cross Connection for DTI DTI Cable Connection via Conn Card Cable Connection via the Conn CardExample of Coaxial Cable Connection Chapter System Data Programming HOW to Read this Chapter DTI Assignment Startdescription DataExample of 30DTI Description Data PatternsDCH Initial DCH Assignment CMA9 ENDTandem Connection Assignment Connected Destination Indication Assignment Chapter Circuit Card Information Circuit Card Information Mounting Location of Circuit Card PN-30DTC-A DTI PN-SC01 DCHList of Required Circuit Card PN-30DTC-A DTI PN-24DTA-C DTI PN-SC01 DCHPN-CP14 MP Lamp Color Function NameRUN CLKSwitch Name Setting Function Check Number Position SW2 OFFOFF OFF ModemSW4 Dip SW Down PN-30DTC-A DTI PCM FRMMfrm RMTSwitch Setting Function Check Name Number Position SensSource clock signal from network is JPS JPRRight LeftDTI0 DTI1 DTI2 DTI3 Conditions Remarks PN-24DTA-C DTI CRC Sense SW0 OFF MDFSW1 OFF DTI0 DTI1 DTI2 DTI3 DTI4 Conditions Remarks PN-SC01 DCH LPBSW0 OFF SW1 Dip SW PZ-M542 Conn Lamp Indications This card has no lampsJP2 Right JP0 RightJP1 Right PZ-M557 Conn Switch Name Setting Function Check Number Position

Related manuals

Manual 475 pages 726 b