2.Use a cloth moistened with alcohol to clean the print head, and wipe along the heater line four times:
Wipe the full length of the area (always in one direction).
Use a clean part of the cloth for each wipe.
Apply firm, even pressure.
Wipe only the following areas.
Guide bar
Heater line
Cover head
3.Allow the wiped area to dry for about two minutes.
4.Close the top cover, and turn on the printer.
5.Make a test print. If image quality artifacts are visible on the test print, repeat Steps 1- 4.
NOTE: It may be necessary to repeat Steps 1- 4 several times to remove any artifacts. If you cannot remove the artifacts, call for service.
Introduction
Setting up the 8500 Printer
Operating the 8500 Printer
Troubleshooting
Site Specifications
Accessories and Supplies