3.While holding the cassette, depress and spread the front paper guide wider than the paper size to be used.
4.Slide the green resin plate of the right paper guide toward the right side wider than the paper size to be used.
NOTE: Be sure to slide the resin plate and not to hold the lever part, as that may bend it.
5.When you load the ledgerT size paper, slide the right paper guide all the way to the right side and remove the lever by depressing it from the both sides. And insert the edges of the lever in the position shown in the illustration.
6.Align the stack of paper and set the paper in the cassette with the sealed surface down. While holding the cassette, slide and fit the front and right paper guides to the paper edges.
NOTE: Be sure to slide the resin plate to move the right paper guide. Check that the top level of the paper does not exceed the line marked on the rear paper guide.