Quick Start –continued
To attach the AccuSyncª monitor to your system, follow these instructions:
1.Turn off the power to your computer.
2.If necessary, install the display card into your system. For more information, refer to the display card manual.
3.For the PC: Plug the end of the video signal cable of the monitor in the video signal connector of the computer. (Figure A.1). Tighten all screws.
For the Mac: Connect the Macintosh cable adapter (not included) to the monitor connector on the Macintosh (Figure B.1). Attach the
NOTE: To obtain the AccuSync Macintosh cable adapter, call
4.Connect one end of the power cord to the AccuSync monitor and the other end to the power outlet (Figure C.1).
NOTE: If you use this monitor at
5. Turn on the monitor and the computer.
NOTE: If you have any problems, please refer to the Troubleshooting section of this UserÕs Manual.
Figure A.1
15-pin mini D-SUB
Captive Signal Cable
4
AS750Fmanualfinal.p65 | 4 | 11/11/03, 2:16 PM |